开云体育

Just map the pins on the connector to the wires on the ribbon cable, use a continuity tester and note down the results numbering the ribbon cables lines 1 - 10. Use a continuity tester to check your

Rafael, sorry I didn’t catch that you were running it on sbitx. I’ll take a look at your repo. I may have some questions.(hihi)

FB Rafael. Yes I run it fine on a pi4 4gb with whatever the iteration of wine is installed with piapps. It works a treat pretty much. But again, the audio plumbing and latency induced by the various

Hi Calvin, I have not seen a tft file with a clock display.? Two possible reasons: 1 - The models with the RTC are recent additions after most development work was done on the KD8CEC/Nextion

I just updated my uBITx v6 to a 2.8” enhanced Nextion. ?Very pleased with the upgrade. ?I did notice that the Nextion has a button battery holder on the backside. ?Apparently these have real time

Lou, Don’t feel bad, I did the exact same thing to my DE while checking the same thing?, I replaced the Pi 4b and it came back to life, an expensive lesson. Joel N6ALT

Tracked down problem.? The green wire on the plug was not attached.? The red and black were but ground was opened . Ubitx is up and working? Yahoo Mail: Search, Organize, Conquer

ps: I wanted to write headless VNC, not VPN.

We use VARA (running on headless VPN, so no screen size issue) using hangover wine. We have production systems for more than a year. It is very stable, but we use our own userland code [1], but is no

Chris, check the supply voltage when this happens first. If the voltage is steady then thats not the issue.

How do you reduce power on the bitx? Yahoo Mail: Search, Organize, Conquer

Hello Chris, I have seen intermittent issues with the mic PTT.? Do you have a way to connect a stereo TRS plug to test the PTT?? Shorting the sleeve to the ring (not the tip) should trigger

Supply current not enough. Reduce TX power and try ? Raj

Actually, there could be many issues to battle that come to mind with VARAHF on the sBitx VaraHF under Wine will likely be cut off or compressed when run in gauge-only mode. Waterfall mode and/or

The original encoders are here:https://www.mouser.in/ProductDetail/Bourns/PEC11L-4020F-S0020?qs=fgHA1UgJI8CzObWXJBveJQ%3D%3D

Hello ,does sanething into a dummy load . The ps is 3.5A Supply.? Maybe something is burnt ,but don't see anything? broken or fried.?? Yahoo Mail: Search, Organize, Conquer

Hi Chris, The first step is to see if it is RF feedback. Does it happen into a dummy load? ?Also need to verify that the power supply is strong enough. 73 Evan AC9TU

Hello , getting my ubitx out and trying to get it to work . Key the mic and shows tx and it just cycles on and off transmit . Not sure if were to start . More into tube radios .chris KD9USK -- Chris

It’s not too difficult to get running under wine but the big problem you'll run into with the sbitx is the limited screen resolution on the 7” touch screen. If you’re like me and want to pack

Ha! I'm assuming ppr got autocorrected there. That's a great point I didn't realize. I'll be out camping/pota-ing this weekend. I'll see if I can count the number of pulses (assuming that software