开云体育

To expand on Gerry's statement, there is no RF out without audio input when transmitting in SSB mode.? That is how SSB works.? The best way to test SSB-transmitted audio is with another receiver to

Hi Dean, How did you tackle the ASoC errors. I have similar errors (no lock when writing register etc) and I am not able to identify the cause. dmesg shows error whenever the PTT is released. I2C

I'm not sure, but I don't think you have a problem.? The power out on voice peaks is likely what it should be, but the readings are average power, which is quite a bit less than peak. Gerry Sherman

Good evening friends I am facing a problem with my new sBitx board. sBitx is working as expected, except one issue with the mic I have. The output is practically nil while transmitting in LSB or

To expand on Gordon's post, there are RealVNC viewers for most platforms, including Android and iOS. Note that the Linux version used for the current V3 sbitx is based on Debian 10 (Buster).? That is

When a problem arises, people don't talk about what they did step by step. But the solution is in the details! I think from your message that you changed the final stage FETs, did you do the Bias

Wait 2 minutes, not 10 seconds. Wait until NTP syncs. -- Gyula HA3HZ

Aaron, I can say from experience that I would not put either a battery or an antenna tuner in the device housing. The best antenna is a good antenna. I dismantled my existing antennas last spring.

If JS8 is your main interest, just gaining screen control of the Raspberry Pi via VNC allows you to have the screen of the Raspberry show up on any device, including Windows devices, because there are

I'm guessing your tablet is Windows? I can't help with the cell phone, but have just recently created a (unidirectional) ICOM emulation for the sBitx that will allow limited CAT control from a Windows

Ok another bag of worms to be opened. Something I'm looking at while I build the enclosure, I am thinking about making the enclosure just a little bit large in case I want to add an onboard battery or

Heat will affect the power output especially on a 50 percent duty cycle mode like FT8. What hardware are you using? DE, V1, V2, V3? You may need to replace the finals and re-bias them if they were

I have an sBitx running v3.02. I have noticed that the output power on FT8 has dropped around 50% since I first got the unit. Output power on CW remains the same. I have only measured FT8 and CW so I

I too have 3.02 and it’s not too much of an issue to wait 10 seconds or so after the OS screen appears. I am more concerned if this is NOT expected as it suggest something else wrong with my sBitx.

February 17, 2024 4:51 AM, "Matt KA2TVX via groups.io" <Penrod72@... (mailto:Penrod72@...?to=%22Matt%20KA2TVX%20via%20groups.io%22%20<Penrod72@...>)>

Perfect, that was the issue!? After the chown, everything is working the way it should! I even completed one of the ideas I sent early.? I've added a button that will export the entire SQL database

Andy, There is a lots more scope with the Raspberry Pico to do this stuff. There is a nice port of the KD8CEC to Pico that could be a good starting point. - f

And link to newest video:?https://youtu.be/nwgTJBSK5tY

Okay - got correct sketch loaded, deleted the old one - all new to me, so I feel accomplished. Even added my call sign to the display! Need to mess with something to reduce the "hum" (shriek?) on the

That is some useful information. I got the cable and adapter to hook my uBITX up to my cell phone to operate FT8 but I had to go to the hospital and I forgot all about it and now I'm addicted to my