开云体育

It's pretty hard to debug this remotely.? One thing that might help aid troubleshooting:

Hello guys, I have HB an exciter board of the DE design, hence, there's no RTC and ATTiny85 onto it I tried v3 software with the DE board, and it failed to load. Is there any write up to mod the DE

Hi all- I just received the V3 Board and would like to try to adapt it to the DE case. Has anyone tried? I realize this is somewhat of a challenge. If anyone has tried this, I would be grateful for

OK, lets try one more time to explain this problem. See included screenshot below. - terminal shows current time as 12:57:09 CST -- correct when queried - terminal shows UTC time as 18:57:09 UTC --

Hi, I need to buy a SBiTX ready to use for use in dx-pediiton, any inf about? Also any test if sbitx have spike ? thank in advance antonio -- _____________________ .'.IZ8CCW.'. Ant

John, It's not related to the sputtering problem you are working, but, I do hear what I think is unnecessary relay chatter on your recording of the DE (not on the received signal, but actual relay

Hello, Due to unforeseen health circumstances, I will no longer be able to participate in ham radio, so I am selling the following equipment. Discounts available for purchasing multiple items. PayPal

Thanks, That was the post with the picture that I was seeking. -- 73, Mark, N8ME

Mark, The pictures are deleted after some time.? That is why I saved all the emails in my offline email folder.? There, the pictures remain. I was wrong about this group.? Here is the link to the

Thanks for the reply, ./build sbitx did the trick! 73 Al

I seem to recall that someone posted a pic of the RPi protection Zener's installed in a DE, but I can't find that. Is it still here? -- 73, Mark, N8ME

Thanks.? I was mainly interested in the RPi Zener mod. I bought the Zener's for that. -- 73, Mark, N8ME

Yes, he says he has in the first post of this thread. It wouldn't hurt to go through it again, though. -- Regards, Dave, N1AI

Just to be clear, my audio files of the CW sputtering were not showing chatter from t/r relays. It’s the same on the V2 (I have both) and the V2 has no relays whatsoever. The sputtering seems to be

Hi Mark, I suggest installing 3.3-volt Zeners on the GPIO pins connected as outputs to control the radio.? Ashhar Farhan has stated that these are now included in the V2 (and now V3)

First efforts at mechanical mounting

Yes, this is known.? The code was written that way and never updated.? It is a very minor issue, as moving the frequency by 1Hz will select the correct filter.? I ran into this when doing some

Ashar, Congratulations on the release of V3. I know it's been a lot of work. I'm looking forward to trying the new software on my DE. I've been away from the project for a while and would like to

This shouldn't really be a problem, because LSB is typically used for SSB on 40m.? So if the frequency is set to anything lower than around 6997 kHz the emissions will be out of band anyway. In the

Have you seen https://www.sbitx.net/index.php/2023/05/05/syncing-the-real-time-clock/ ? - f [email protected]> wrote: