开云体育

Are you seeing this with a dummy load attached? I've noticed also that occasionally I get a bunch of garbage due to the IC2 bus not properly initiating. A shutdown/reboot fixes that. If you are

My Sbitx v2 has been shipped. Delivery 22 or 22 June. In the interm, I have read thru most of the paperwork and viewed videos to help prepare for its arrival. 1.? When it arrives? how do I

Farhan, Using a Jetstream 25A switching supply. I made an adapter to Power Poles with 12GA wire. --Neil

My solution was use a .3124 inch end mill bit in a drill press and do a plunge cut to the base aluminum though the fins.? That clears the fins and provides a flat base for the nut.? With that a

Neil, Next, with a dummy load connected, if ypu just run the txcal from webui, it should bring the power up. I hope the power supply is juicy enough. -f wrote:

Sorry, this is my V2.? The DE is waiting for a dose of ambition to perform the mods. --Neil

Farhan, This is from a known good power meter. I ran the calibration routines back when you first discussed them so the sBITX power readout is pretty accurate up to 17M and a few Watts off on 15 -

Neil, Is this power output reading from your radio's display or is it from an external power meter? Can you remind us if you have a v2 or the de? - f

All, I had the same issue with my DE sbitx.? I had to reload the image on the microSD card, do the update, and then reboot.? After that, the mic worked again. Before I did the above, I checked

I would strongly urge that you do your tests into a good dummy load with known good connectors ... ideally with no cable ... before you do anything significant inside the rig.? And make sure you

Thanks Evan. I finally got around to doing that calibration. The number I settled on was 24999450. There doesn't seem to be any audible change unless the number is stepped up or down by more than 100.

Sorry to reply to my own post, but I was hoping someone could advise me. Is there something I should be doing (see below) or should I be happy with these numbers? Thanks! --Neil, W2NDG Hi

John, This update is for both editions, DE as well as V2. When I had pushed out the update, there was a problem noted in coming back to receive from transmit. I fixed that too, I recommend pulling in

Hi Ashhar, let me ask, just to be clear, the latest ./update is for the V2, which has no physical LPF relays. It seems to be working on my V2. What about the DE (which has upgrade #2, and the T/R

mine is the same..Minimal rf output on SSB with normal output on cw and 2 tone.. on cw and 2Tone about 22 watts on 17 meters and 2.1 watts at best on SSB.. software issue most likely..

Unfortunately I just experienced what you all have been talking about. One of my inserts came loose (V2 #89). My quick solution was to put back the stud but secure it from behind with a M3 30 mm screw

Joerg That would make sense, but so far you and I seem to be the only ones having this exact issue. Mine is the latest software (updated Friday) and software would affect everyone using that version.

Where is the signal s-meter display on the sBitx v2, I can only see a waterfall? thank you.

Run "git log" from sbitx directory wrote:

How can I tell what version of firmware my radio is using? Thanks Wd8axa