开云体育

Have you installed an SWP/Power sensor?? That was not included in the sBitx DE V1 radio.? You would need to build/buy a Stockton bridge and an ATTiny85 and wire them in.? Ashhar Farhan did say

In the file tab "ubitx_v6.1_code" in the Arduino IDE, there should be a line about a quarter of the way down from the top of the file that looks like this: bool isUsbVfoA = false, isUsbVfoB =

Last chance for someone to step up.? After keeping this going for close to 6 years I have decided someone else can have a turn.? All the details are in /g/BITX20/message/102225 The

So On my sbix DE v1, i upgraded to the latest software version with a fresh sd card.? I am trying to calibrate the power output, and I am running into two issues.? The first is that with the drive

the end of the post is: "bool isUsbVfof"

Could you post the compile messages/errors ?? ? Maybe those will provide a clue.

I use the Heil FS-2 foot switch with my Icom 7600 and my 8410 amplifier and I’d use it with my uBitx v6 if I wanted to use it with an amp but for me that would be conflicting with the whole idea of

I created a Discord for sBITx. Great place to text chat, voice chat and share videos and pictures. Here is the link for invitation. It is a public chat. I can make private once we get people to join

Thanks Dave.? More info: ?I’m all cw and a qsk operator so would like that capability. ? ?I want automatic amp PTT /?switching as I plan to?use the rig mobile where a foot switch isn’t

Thanks Evan, I did have the V5 firmware loaded.? Because of your directions, I found and installed the correct one.? The problem still exists, but I now have a clue of what the problem is.? When I

I've run the new software a number of times and it will not compile. The stock software gives me no change when changing from USB TO LSB.

So whatever you do, STRONGLY decouple from the switched +12 volt line. That line can introduce all manner of rf problems. Gordon KX4Z [email protected]> wrote:

The easiest way to key the radio and amp (I am doing this with my ubitx6) is to use the heil footswitch FS2. I did not want to do any wiring inside the radio. It has two output cables with one going

I can not read the screenshots.? They would need to be at a higher resolution or larger. The file you listed could be either a v5 or a v234 file.? Verify that you have the files from the uBITXV234

Thanks for the info Evan. Here are some screen shots.

cloyesjn, First, verify that you have the correct program on the radio.? Ensure you use the settings in the Arduino sketch or the hex file for version 234, not version 5.? Post back if you need

I using a v4 board with CEC V 1.2 firmware. When I turn on setup, there is no audio.? I want to calibrate the frequency and adjust the bfo, but no sound is available.? All other settings seem

Hi Ashhar and all, I realized the sBitx v2 is coming with a very old Linux distribution, which is the currently based on Debian 10 (Buster, oldstable, soon to become oldoldstable), with EOL set to

I want to key a home brew amp with?my brand new just arrived?sbitx xcvr for occasional QRO use. ?? Like most amps it requires a closure to ground to make it work. ? ??What are some ez ways to

Paul - thanks - saved me some time googling! 73, Dean KK4DAS