开云体育

Hello Gyula, Thank you very much. In the meantime, I will try my best when I get the FET. Ichiro JE1JGC 2023年5月21日(日) 18:14 HA3HZ <gyula@...>:

Joel, I believe that you’re supposed to use an external SWR meter. Here is YouTube video that Ashhar made. https://youtu.be/iJLXfQv_C6U ( https://youtu.be/iJLXfQv_C6U ) The software versions are

Well, I can't go back to the original software. It seems that Win32DiskImager did not properly image the contents of the sd card that came with my sBitx. I am in the process of installing the V2.1

With the caveat that I know this is *not* a classic uBITX, and I didn’t see the prior thread where you probably gave more relevant details… so my comments are probably not useful ;-) I just had a

I'm Happy to say my friend met with Farhan this morning May-21-23 at the Dayton Hamvention, and everything was taken care of. Great service thanks for helping my friend Jerry. Pete KB8EMD

my sBITx works great, my friend bought just the board kit he used his own raspberry pi 4. I think his pi-4 may be messed up, not the sd card that came with the kit. when I have time I will try and

I understand. Use a properly sized wire jumper from one solder point to another solder point. I'm sorry you had to go through this. Don't give up... -- Gyula HA3HZ

Pete, The source code is already inside the raspberry pi. It is in the directory of /home/pi/sbitx. Github charges money for private accounts. Sbitx is a public repository that can be accessed for

Hello Gyula, I will contact support. In the meantime, I have ordered the FETs and will see if I can replace them myself. But it may be difficult since some of the board patterns are burned

Hello Ichiro, Write a message to support@hfsig.... I'm just a user from Europe. -- Gyula HA3HZ

The screws were and are tight. I'm not sure which forum post you're referring to...I found one about 'for testers only', 'death by calibration'. For now, I'm going to reload the original

Today, Saturday May 20, 2023 after placing a pair onto the power leads plug them into a power supply I?hooking up an antenna opened the manual read, ok glanced at it waited for raspberry-pi to boot,

Hello Gyula I checked the FET and it seems to be broken. It seems a bit out of my control. Can you fix it with HFSIGNALS? Ichiro JE1JGC

At txcal, the output stage is adjusted per band, which is protected by ALC. It protects when the hardware is fine. Something happened with the hardware here. The FETs have become shorted or something

I also made it to the booth yesterday and was pleased to meet Mr. Farhan and thank him for his work on these delightful radios. Jack N6LN

I tried the manual’s recommended setting of 25 and there was basically nothing. Bumped up to 50 and there was some slight deflection. Checking the CW on the watt meter it looks like I’m getting

Hi Farhan, You may wish to consider using the 'Raspberry Pi ' *SD card copier* ' next time to duplicate the image to a smaller SD Card

Hi everyone, After performing "Calibrating the SWR/Power meter", I could only get 20W output at 7MHz. When I performed "txcal", the power suddenly turned off. It seems that the protection of the

Yet another on sBITX https://www.youtube.com/watch?v=Az0TWvX5v3Y -- 73 Bob? KD8CGH

Farhan visited Northern Virginia on his way to FDIM.? In these videos we talk about the BITX 23, the sBITX, and the High School Direct Conversion