开云体育

Hello Jim, We have never had any issue shipping to any address in the US. However DHL does not ship to a PO Box address. So you will have to give a street address and it will be delivered. However if

I have a problem that is similar and may be the same. Will be digging into this more later. Got an audio report that said it sounded distorted. The mic is the one that came in the uBitx v3 kit. Will

I’d call DHL’s customer support line and see if your address is recognized as a valid address.

I'm planning to order a Bitx kit but I'm not sure DHL delivers to my rural address in KY.? Sometimes UPS and FedEx have problems locating me.? USPS does a great job.? Does anyone have experience

Ashhar, I was mistaken when I said the spur moves in the same direction as the main signal. It is just the opposite. If I tune up in frequency, the main signal goes up in pitch/tone. The spur will go

Brad, The rx audio output from the codec is mono. The other channel is used for transmit circuitry. This rules out stereo output for the rx. The binaureal sound is not possible from the architecture

Good night people.? I have a ubtix V3 and I was using it in cw and I observed it with bad contact, turning on and off and then it turned off, I checked the 7805 regulator and it was very hot, I

With in the circuit. Would it be acceptable to apply 12v? to Pin 6 and Ground to Pin 2 to see if i can get the relay to switch...having issues with Pi doing what it needs to do to switch using FT8 to

A friend of me developed a circuit board for surround sound cw.? It's pretty neat and as you tune past a station the cw goes from one ear to the other.? It gives another dimension to the perception

One of these plugs into the first (leftward, towards the board edge) micro-HDMI socket and converts to the large HDMI plug. The other has a HDMI socket that mounts to the chassis.

I'm setting up a 2 Meter transverter to my uBITX. My normal setup is: 1) uBITX 2)Nm0S 4-S Tuner 3) Antenna My question is should the 2 Meter transverter go before or after the tuner? The transverter

Jack I installed it (V6) using a new Nano and the first time had to choose Uno instead of Nano as the board (using Arduino IDE) and the "new" rather than "old" boot loader. ?When trying to upload as

Got?n8me_2_vu3gao_mods loaded and green CAT , the Test PTT turns red. But I don't see that as TX on the Ubitx, or anything on the Ubitx change. Any ideas or settings?

Just wanted to say goodbye to everyone,and enjoy ur sbitxes,and such. Im changing paths in my Amateur radio career. Just going to buy USA made or make it myself. Not to be insulting to others, and

Hi Rolf, You can do the \help and \h2 commands to see a list of commands. The commands I have added are on help page 2 (\h2). I just did a push to git a few minutes ago updating the help screens, so

Temperature compensation is only part of the game. The other was using a coil form with stable temperature characteristics like ceramic.? Most ferrites and powered iron cores were to be shunned or

Hi Goody, is there a list of commands that are available? I like to update my sBitx version and try the new one. Thanks a lot for your effort Vy73 de Rolf, DL8BAG

I specify, I am currently working with a 12mhz SSB filter

Hello, a little code reading before my question on value of frequencies *Code UBITX V4.3* The uBITX is an upconnversion transceiver. The first IF is at 45 MHz. The first IF frequency is not exactly at

Did you install a micro HDMI socket on the back of the case? I was having trouble finding one.