开云体育

There is no discernible reason why the power out is not behaving for all bands. With the resistors removed (source of IRF510s) a bias in the range of 100 to 150ma per device is fine. However the

Vince three things I'd like to have... BOM, Board etch diagrams some coils have no data. Fortunately I'm used to doing forensic engineering made a career out of it. There are issues in the transmitter

I reimage the sbitx software and booted the radio. Now the radio is able to recieve and does not shutdown when I attempt send CQ in FT8 mode. However, FT8 is the only mode that will transmit any power

On what system? I run linux on everything to Eclipse and straight text editor (xed) do the job for me.? Ben trying Geany as well.? For Arduino I use their IDE as its the same on all platforms. I use

Reason is it may not be putting out 6W but far more. I found no real correlation between front panel power setting and what came out. The BIRD-43 wattmeter was indicating for 6W depending on band up

I’m using the microphone that came with my uBItx with my SBitx. The red LED is on all the time. Is that normal?

Hi Mark Yes i would like that... you can email vince320@... when you get a chance. I've been struggling with my sBitx.. made some magic smoke for some reason... vince

I hooked my SBitx up to my current limited 12 V supply and at 5 watts output (confirmed on an external meter), the unit is drawing close to 6 amps. That’s 72 watts input for 5 out. Is this normal?

Are you suggesting removing the paint on the exposed side of the panel with the countersink, or would it be sufficient to do it on the inside side, so you don’t mar the appearance? I did a quick VOM

What IDE would you recommend for the RPi 4? FWIW, VSCode runs well on the 4, particularly if you replace the SD card with a USB SSD. I have figured out all the include paths and can use the code

UGG.. got a 50v...? ;=(( that's not going to fly long.. I would not run this at full power anyway, but again better to be safe than sorry.. I'll have to hunt up a 250 or 500 one. V

Allison, thanks for the feedback..I've had some issues, and I am sorting through them now..blew R403 and it burned the pad off on the Coil side... as well as I think the T/R relay is welded to

Ditto on Evan’s warning about enlarging the holes carefully. If you look at the 2.8 Nextion you will see a small ribbon cable on one side. You want to work on enlarging the hole from the opposite

Could you do: ps aux|grep X ps aux|grep lx (That second line is grep lima x-ray….) I’m curious to see what the command line is for the Xorg process, and is user pi owns the various lx*

Curt, Here is a link with the details on how to do the 2.8" Nextion conversion of a v6: http://ubitx.net/2020/01/06/a-v6-nextion-display-conversion/ One point, with careful file work on the Nextion

Yes, I did another build. Same error. as to the other question no, I am not trying VPN. I use the cmd line to show the error. Invoking sBitx by clicking on the GUI icon similarly starts the process

Are you trying to run sBitx from another computer in a remoteterminal (like Putty)? Not possible. You need a remote desktop or vnc or ...? de oz9ny, niels

Did you do a ./build again after fixing permissions?

Same error

Rolf , maybe that's what I saw too.. just a picky decoder for cw... but just could not get it to work... tried several signals... Brad