开云体育

You might try Xloader if the PC's or laptops are running windoze OS's; no equivalent for linux flavors I have found yet. I just put arduino IDE into a linux box and tried to get a hex file imported

This is exactly why we don’t need to split up the forum into version groups. ?Nice piece of work Andy. -- Sodypop?

OOPS --- I forgot to attach the PDF file - here it is

Dave, I wasn't sure if it would be useful. Now that many have confirmed it to be so, I will link it up in a day. - f

Just in case you'd like to read through the software operating manual to see what it looks like when run on the Teensy 4.0 with our T4-NANO adapter (NO hardware mods are needed to the uBITX V6

The sd card must be empty. Best is : format first!! Herman vanaf z'n IPad.

The nextion will read/upload the file in the SD card when you power up the nextion.? The screen will show a brief % progress display, then a compete msg.? Then power down.? Pull the card.

I know about AvrDude and USBtiny and similar methods of getting HEX into the Nano and that's fine for us semi-technical types.? What I have been looking for and unable to find is any super simple

Barb, That sounds like a great addition to the V6. Does it help with the lag in the CW keying? I love the V6. It is a diamond in the ruff, and am excited about the upcoming mods and improvements.

Skip, thanks for the advice, as I was trying to figure out how to insert without scratching up the traces on the board. Great idea :)

Arrr! Spellcheck got me insurance should be insertion. Skip NC9O

Once the pre program image is loaded, I remember we have to take out that sd card as it is no more needed. Balance will be looked after by firmware. I do use 2.8 version. Sarma vi3zmv.

I've had difficulties getting into the setup menu with a long push, because the encoder is really sensitive. I find it very helpful to hold the dial still with one hand and push the dial in with the

Yes Joel this makes perfect sense. Because you are leaving it in permanently you could remove R70 (a 10 Ohm resistor) and use its mounting pads as your filter insurance point. Skip NC9O

Correction: It is R2 on the Raduino-TFT schematic (new for the v6 uBitx) that is the pullup to 5v for KEYER. R2 and R3 on the main uBitx board are used to pull down that KEYER signal to initiate a dit

Thanks for all the input. I put the power to the receive rail, so it now the filter is not powered during transmit. So not the RF feedback is gone. But....I can’t here the CW side tone now. After

Having been in and out and back in ham radio several times since the late ‘50s, I have to say this Bitx group has been probably the most rewarding and fun time I’ve ever had with radio. ?I love

I have a ubitx V5. It works fine with the 2-line LCD it comes with. I have the 3.5" Nextion screen as well. I updated the ubitx software to KD8CEC's 1.097 NX_Hex file with no problem. I then copied

Note that CW-KEY unbalances the first mixer at D1,D2, allowing CLK2 out to the power amp. CLK2 from the Si5351 is at the transmit frequency during CW transmit. CLK0 and CLK0 are disabled during CW

Alex, i modified my V6 with nextion display.the hardware modification is not that hard. I put together a post to explain all. Though you have to peogram your arduino in the kit to make it work.