开云体育

I suppose the sunil vu3sua is also selling these boards from his Indian site

V4: One you do the spur mods these should reduce or go away! Raj

OM how is your output power on CW?? take power readings on CW even if you don't use this mode.? this will tell us how the PA etc are working. some experience weak audio drive that hampers SSB

[email protected]> wrote: Thanks Jerry, was helpful... & here's online calculator too : https://www.random-science-tools.com/electronics/dBm-Watts-volts.htm Guys, any way can we know voltages approx

Congrats on turning it loose Don, those are some really nice results.? I'm envious of your antenna doing so well without a tuner.? I hadn't noticed those pie charts before, but yes 30m is a pretty

Thanks exactly what I looking for......

Good idea. It bugs me too when I power off the radio and the raduino is still on. It powers the radio too because when I have my pan adapter hooked up I can still receive signal, just a little weaker.

I read that bit about BFO adjustments till static sounded "good".? i suspect that the "good" guidance works just fine -- as soon as you ear learns what good static sounds like. hahaha. You also have

I need your Help, reaaly no Idea for this low, very low Power Output.. ...if there is an way, an idea or something i could do it was not described in any post till now or i read it not because i have

I finally got around to putting KD8CEC's outstanding FW on my V3 ?BITX.? When I'm not using the rig for other things I leave it on to rx WSPR.? Using CAT control for band hopping is fantastic.? I

---------- Forwarded message --------- From: Sandeep Lohia <sandeeplohia12@...> Date: Sat 18 May, 2019, 3:28 PM Subject: BLT To: <emrfd@...>

My uBITX v3 has been sold.? Thank you all for looking. 73, Rod WA9GQT

Still scraping the egg off my face..totally missed the obvious link on the hfsignals page.

So it's a V3 Regards Olivier [email protected]> a écrit :

Hello all seems to be a TDA2822 as Audio amp Regards Olivier

You can find historical documents on the original bitx20 at http://golddredgervideo.com/kc0wox/ They date all the way back to some of the original boards. Leonard

All: The source code and schematic from my FDIM talk on the Morse Code Tutor is now available in the Files section on SoftwareControlledHamRadio groups.io Group. | | | | | | | | | | |

Do you have a link to this video? 73 Joe KD2NFC

OM the most difficult to source components (crystals, toroids, etc) can easily be seen here.? the other parts are more common, except the new v5 suggests using some VHF NPNs in the 45 MHz

Thank you Mark for that. I want to build it and if it works then I can make mods. I will build each section in modules so that if a mod doesn't quite work the original should work assuming no major