开云体育

/g/BITX20/attachment/63028/0/antuino.png -- www.bitxmap.com ( http://www.bitxmap.com )

What model of Arduino is the code intended for? Thanks Mike N2HTT

Joe, Got a test bed working. (Probably spend a couple hours moving to a new case so that I don't accidentally short something....) Looks good on my enhanced 5.0. Takes longer to do the update, but I

Sorry, but looking for the glcd library I also found lots of the same named libraries. And they are different. I tried more than one. But I got at compiling various foults. Specialy in the line

Sorry, But looking for the

Hi, I planning on using this STM32 ARM board manager. This 32 bit ARM extension for Arduino is written by actual ST Microelectronics software engineers. It looks like it is based on the same libraries

In case we are lucky, you need to bootload the arduino with so called Nano "old bootloader" . Later try LOADING ITX40 SKETCH FRESH. LET US SEE WHAT HAPPENS. Sorry for all caps.

Hello guys! I nead help for my Raduion problem.. My BITX40 arrived and it was functioning fine. While I was waiting for enclosure to arrive I started to implement some mods to make it better suitable.

This is interesting. There could be two possible explanations: 1. There is gain compression. This is possible due to the two stage IF amplifiers. 2. The step attenuator is off-calibration. One way to

Also I think the Spectrum Analyzer page needs more work actually even the band analyzer. I may have been able to adjust their position and lengths of the analyzer graphs but the slider does not seem

I am attaching the HMI file. This is the version that included the graph in the main screen if you use the stand alone analyzer which includes the CW decoder. I haven’t stretched the CW decoder

Joe, Thanks! Looking forward to it. Be happy to beta test it when you feel its ready, Were you able to get the original art work from KD8CEC? Bet that would make you work easier.... 73 Mark AJ6CU

Yes it’s not friendly when it comes to resizing, and it’s even worse when there’s graphs involved. I have a 5” setup that I’ve been working on keeping it as original as I can from the

BTW: My respect to anybody that has undertaken this effort.? This GUI builder has got to be one of the most basic I have seen in many years. The lack of any internal resizing makes things difficult.

I have been playing around with the Anduino. I inserted a step-attenuator between the RF input and RF output ports. With no in-line attenuation, the measured RF output is -16 dBm. As I added

https://www.arduino.cc/en/Guide/HomePage _._

Peeps, I just landed back home an hour ago. I will start putting the documentation for the antuino together tomorrow. - f

Has anybody made one for the Nextion 5/Enhanced running KD8CEC 1.2? The GitHub "5" appears to be a 2.8(?). (Upper left corner small image) Thanks Mark

I don’t recommend installing the Arduino IDE with sudo apt install command. You usually get a really old version from the distribution repositories. Something like version 1.0.5. Better download the

Hi, If the program you are trying to port has a traditional C main routine and it starts out by doing init stuff then finally has a while loop, like 'while(1){ --lines of code--};. Then put the stuff