开云体育

Arv, The problem of online RX or for that fact QRSS and WSPR sites is antenna alignment. If you antenna is not "aimed" that way the result is it could have been a long path or worse "off the side".?

Our support is via hfsignals@.... the same as our paypal id. - f

The inductors on the pcb are fragile and the vendors take a lot of effort to pack well for its trip to the purchaser.Likely to receive not so gentle handling in the post or courier so unfortunately

In the last few days, I’ve learned how to do FT8 and probably JS8call as well. I’ve been so busy teaching emergency communications that I haven’t been able to fiddle with my radios much, but

Jack, Not showing off, no one is paying for it.? However when someone claims a loop that 1-2db below a EFHW (or a dipole) that's pretty close to saying my 10 year old Tacoma can?win at Indy.? In

You could always just wind the inductor yourself for much less than it would cost to ship one around the world. The manufacturer isn't responsible for damage during transport, so you could go after

They also state on their webpage, the email address of the only place you can get support. My bitx40 board arrived with 1 of the toroids ripped from the board. I emailed them about it at the provided

Wow. You must seriously lack many skills needed for life, not just in building a radio. To blame OTHERS for your inability is hilarious.? Glad I don't live by OR associate with you.

Hi Jack, It's a hobby to me as well, Constrained by finite time and money. There are many miracle claims, just using cheap & simple gets overlooked. Your reference the realworld ingenuity of to your

Guys, He is talking about the BITX40, not uBITX. We seem to have forgotten the elder. 73, f

Jack, ham radio is a hobby for me, too. Please keep up your experiments and post anything you care to share. As a renter, magnetic loops interest me, and *your* experiments will improve the

John, You are refering to the BITX40 kit, rather than the uBITX. I entirely accept that the presentation could be better. I am working on updating the BITX40 documentation and it should be through in

Good going! [email protected]> wrote:

Trying to update to CEC firmware after long ownership of Bix40, I'm still an utter newbie. Can tell me how/where to obtain the Pin Change Interrupt library - and install it? Or point me to an existing

Jack Since your loop is small it could be rotated and a remote receiver and antenna used to derive a signal strength pattern. This could be automated if you use a stepper motor rotator and automated

Of maybe a drone. https://www.radioworld.com/tech-and-gear/using-drones-for-signal-measurements Tom, wb6b

Ken, and others John and myself have discussed this off-net. Turns out that I may have miss-interpreted his post. He is well qualified and experienced. He just posted some thoughts that probably we

John and myself have discussed this off-net. wrote:

Don KM4UDX Thanks for the kind words. At my ancient age some things come about from errors and experience. Arv K7HKL _._

Ha ...or one boat and one helicopter ...easy-peasy Jim