开云体育

Yep

Is this what I am looking for

If you want to fix that, just click on the p1 attribute on the right side (prob in px page) and click on Delete. You were compiling it correctly. Anyway, here is the new tft. Let us know if it works

Hi Kevin, It sounds like you may have accidently added a picture to the sketch. Let me recompile the hmi @270 degrees and I'll repost. Did you use my hmi or Ted's edited version (bigger tune step

Where's this daughter board that everybody's talking about? I went to the website and I see no reference to it whatsoever? Thanks, Roy WA0YMH

Adding 160m LPF will help a lot. MiguelWP4ZI On Thu, May 2, 2019 at 5:37, Lawrence Galea<9h1avlaw@...> wrote: Interesting. Which μbitx, 3, 4, 5? Can you make the LPF board separate or at

Dear I need one VU2NSK

Hi Nick, Put my name on one please. Regards Jean ON4AEF. Sent: donderdag 2 mei 2019 15:45 To: [email protected] Subject: Re: [BITX20] VK4PP Ultimate uBitx Daughter Board. #ubitx #filters

Hi Nick, Put my name on one please.Regards Dave G0AYD.

Looks like a 1 Meg variable R in lieu of the switch might be the easiest arrangement.? Only 2 wires back to the board (C and G), plus variable AGC release time. 73 Jack KZ5A

A rotary switch for AGC timing/control looks like a smooth idea!?Here's a deal (

An alternative if preferred would be to use a sub-miniature MIL spec rotary switch to switch between? common, off/slow/fast just as in the ND6T wiring diagram. Just completed this board with no

The uBitx also runs fine on 15 volts and has a little better sensitivity.... possibly? a matter of perception alone due to increased AF gain.? Currently running off of a 20 volt Li-Po drill battery

Interesting. Which μbitx, 3, 4, 5? Can you make the LPF board separate or at last can be cut off? Also how about including a 160M LPF position? Guess this would entail software changes, but I am sure

I use a 12v regulator chip on the input line for both my uBitX and my BitX40, which have the PA power lines connected directly to the source. Initially I did this to allow for excursions above 14v

Here, guys - please try this copy. I don't see a reference to P1 anywhere in the PX page and I don't know how you're seeing one.? It's a curiosity, for sure. I'm using the Basic version of this

In page px there is something wrong with the pic Id which is the picture in p1. I’m not even sure there should be a p1 in the px page. Joe Kd2nfc

Ahh okay, no worries looks like I’ll have to put it on the to do list. I do like the functionality. Joe

If it is any help, the compile error message is: Error: Page:px Error:p1.pic InputVal Invalid:Invalid Pic ID Cheers, Kevin VK3DAP / ZL2DAP

Hi Sam, I am using your ubitx_35_complete_Enhanced_a.tft. Looks really good.? However I am at the stage where I am tweaking things and having the nextion card reader at the bottom is a PITA.? I