开云体育

I am using same case. Please note the interconnecting wires, with the specific mating connectors, are a useful add on to purchase. See ubitx.com website hosted by Sunil for a growing set of

Would be nice to figure out why this happens. A few possibilities: ? ? A)? Miswires, static discharge, reverse voltage, connector installed one pin over or reversed, blow the processor? ? ? B)?

I built a mic amp and compressor/limiter to use with my uBitx V4.3. The op amp in my mic compressor/limiter is sufficient to directly drive the dual diode balanced mixer. I was wondering what input

That needs to be on the homepage - for ANY Bitx! The number of queries here ... :(

since the ubitx has "devolved" to using the lm386 audio amp like nearly every other qrp rig in existence, I thought an audio band-pass filter might be useful ...as per attached photo, an LC lowpass

Just got the ubitx case today, as per tracking... AND, according to PayPal I received a shipping notice with tracking number from HFsignals.com last night... oh my!? I am ecstatic.? That means my

I have 2 ea raduinos removed from working radios and one from a UBITX for sale. Contact me off list K6kwq good in QRZ Sent from Mail<https://go.microsoft.com/fwlink/?LinkId=550986> for Windows

Agree. That's why the OOP/C++ stuff is in the last chapter of the book. Jack, W8TEE

Jerry: Someone once said C is powerful enough to let you shoot yourself in the foot, but C++ has the power to blow your entire leg off. I think that's true. There are features in C++ that I rarely

It's a simple interconnect device. Power supply goes to "IN", "OUT" goes to the radio's Power input, and "SWITCH" goes to the on/off switch. This centralizes the power connections and if you need to

Mike KA4CDN I use

Jack, Yes, an Arduino programmer should understand that "Serial.print()" is trying to access the print() function in the Serial library. But that will eventually sink in even if the new programmer

I stand by my advice. Yes, you do need to figure out a bit of C++ if you want to understand ArduinoLand libraries. But you don't need to understand those libraries when starting out with programming

Yes - please install it.

Check the TSW website, www.w0eb.com/Page2.html we have a raduino clone kit available. The sockets are included in the kit along with a new NANO. The clone kit, once built can be used with either the

This is a genuine question. How would I use this switch kit? Roy WA0YMH

PULL-UP Resistor! -- Mike Hagen, WA6ISP 10917 Bryant Street Yucaipa, Ca. 92399 (909) 918-0058 PayPal ID "MotDog@..." Mike@...

I have my V5 assembled, but not yet powered up. I'm wondering if the resistor is still required per the below instruction. * The CW keyer has to be wired even if you don’t intend to use CW. Yes,

Sorry, Don't know why I got doubles of all the attachments :-p Mark.

Hi, Just thought I'd post the schematic and a picture for the audio pop fix I just did on my uBITX V3.? It works great and saves the ears a lot. If you check the top part of the photo, you can see