开云体育

I've been using 2.0 all day today. Lots of contacts around the globe. Any problems with it should be answered in the Getting Started guide, such as the one Art mentions below. Vince.

Thanks Gw0wvl ' Marc ' ...

Rocco The errors, assume, you are referring to the ssl/tsl error. Easy fix (guidance) on the WSJT-X software website. Fixed with a simple download. I am up and running. 73 Art

With all the errors I am seeing today, I am afraid to upgrade. I am doing the grid chase and have been using 99.9% FT8. If most people stay on 1.9, I feel like I am shooting myself in the foot. I was

Ft8 2.0 monitor 7074 up. BCNU DE N2LO~> Sent from Xfinity Connect Application

If you are operating FT8, it is recommended that you upgrade to newest version (2.0) as soon as possible- https://physics.princeton.edu/pulsar/k1jt/wsjtx.html *Anthony Luscre* *K8ZT* Ohio Section

Sorry I am also unable to open the gerbers...also JLCPCB rejected my order when I tried to order boards with the file. They say that..."the D cade is incorrect, please fix and re-upload"... 73, Tom,

Another member just received a new ?BITX board and it has new relays.? Farhan reported that to be the case but we hadn't yet seen a board with the new relays 'in the wild'.? There's been no

Jerry, lets not forget about the oscillator for the Si5351a, be that 25MHz or 27Mhz, that is another potential source for birdies. -Justin N2TOH

Sadly the 8 output version of the Si5351 has no easy way to set a default frequency on boot up, as the 8 output version has better isolation between outputs, and could also have been used to drive the

Joe Taylor joe@... via ( https://support.google.com/mail/answer/1311182?hl=en )?lists.sourceforge.net? 6:11 AM (3 hours ago) ?? to WSJT The WSJT Development Group is pleased to announce

A) Hi Clark, yes I recall there was an issue with the full swing vs low power with the ATmega644p/ATmega1284p the oscillator was interfering with the serial port in full power mode, it made for

Hello everyone. Here is the picture of the uBITX I got just today. So from what I am understanding is that I do not need to replace the relays. I ordered them from Arrow anyways and have them on hand.

Hello Andy, Yes sir, my uBITX is now FCC compliant (though just barely on 40 meters, CW mode) except for one spur on the 10 meter band. Ripley The words are mine but this iPad does what it will with

Lee: Did you get anywhere with this? I looked into parts but it would be dealing with 3-4 different vendors. Bill

Hi Ripley, ? Thank you for the clarification!? My intent was to relate to Jerry that the bidirectional RF amps were still stock.? The amp immediately prior to the filter (that used to feed the

Hi Andy, A slight clarification, actually I replaced Q92, Q93, Q96, Q97 with 2N2222A and the emitter resistors along with Q90 and the change of resistors per Allison’s recommendation First. Then

TNX for the suggestions... Values are with RV1 adjusted to near maximum power.? Reach max before end of pot travel. FWIW, I have substituted the factory 45 MHz xtal filter with one of the two

A number of people are working to meet different thresholds of 'take care'-edness (two more times in print and it's a real word).? A few (probably in a nod to the phase noise wars) are pushing for a

joshuaclough4@ Start with carrier balance pot and adjust with NO MODULATION for minimum power out. There should be a noticeable null at about mid rotation. Likely the carrier frequency setting is off