开云体育

QSX from QRP-LABS is coming soon, so you should start :))

are there any plans in place for a v5 uBitx? need to know if I need to startpitting pennies back to purchase it. -- 72 and God bless KD4EPG

We don't actually use the onboard switch anymore. We have gone to a separate toggle switch for power, mainly because the rig then "comes up" at the last volume level. That said, our needs are likely

I got them from Digikey in 3 days. Had to order something else, so shipping charges were not an issue.

I am using a 50k double pot without a switch on my 3 bitx radios I ganged the two halves in parallel so they are 25k.? I pulled them out of various other equipment. like old computer speakers.

if stock firmware is removed, by using CEC firmware, newer facilities like ATT and IF-S the issue might arise, due to improper management of ATT and IF-S facilities. I suppose the reporters may have

Sir, My ubitx v4 also receiving sensitivity is very poor after calibration. The audio is very low. I am planning to add one external Audio Amp.? Where I purchase? Raduino Board for my ubitx v4 ? *

I believe that the replacement with the Axicom relays should be a must in any case. I hope they will soon arrive... to make some rudimentary check... bought them on a non-sale price and still been

this certainly looks like an audio problem. these challenges are often difficult to diagnose without a full signal path inspection. do you have a signal generator ? can you hook a small oscillator

re PM for "by" read buy.? typing too fast here...TEF

Mr Trager is so unimpressed he is going to package it up and send it back as is .. a single band SSB receiver.? He is fed up with wasting time and money (full set of? 12 crystals was used to select

One note: DO NOT put relays in sockets as the performance degrades. Raj Hi Gene, There is no final solution. So far my conclusions... the harmonics floating around the board is the cause of the spurs.

Hi Gene, There is no final solution. So far my conclusions... the harmonics floating around the board is the cause of the spurs. Changing the L5/7 reduced the spurs but not the cause which is

Thanks David

Congrats on staying with it for so long. Mine has worked well so far and I have mode several improvements to it. But from what I am reading about other folks problems, I must have got lucky. However

Part of the mistery solved... If you remove R253, you can still hear CW side tone on speaker, because Arduino is using PWM pin for generating audio. That pin behaves like an antenna, and signal from

Sorry to ask but I been offline for a few weeks and the subject seems to have died out (after reading past posts). So is there a final solution for the spurs/harmonics for the V3 uBitX? * Axicom

I just ordered a couple of these from Adafruit. https://www.adafruit.com/product/3481 Dave - AI6K

Does anyone have a link to a 10K pot I can use for volume control for the uBitx that has power switch. Oddly the one that came with the kit went bad on me. It just freaks out when I touch it and can

I've got to think about that... I want the person in phone mode to hear my cw. If they're in USB, don't I have to transmit CW-reverse to get into their passband? Ed - aa2mz