开云体育

Well, that seems pretty dumb. What difference does it make to them if the shipping is the same?

It sometimes takes me longer to find a seller that will ship. And I do a lot of cussing t the ones that don't. Are a lot of places that some will not ship to for reasons unknown. Wayne WA2YNE Old and

Wayne and all, And he won't ship to Alaska or Hawaii either. And doesn't cost anymore either. I pass these bozos up all the time. Also annoyed. Paul KL7FLR

I found another seller, and bought 2 sets, so I'll have 4 grills. I have a small speaker that came with the parts kit I bought, so 3 will be needed, and it does not hurt to have a spare. BTW, I also

Allard, No, v2.04 works great for me Tnx Paul Sent: Thursday, September 6, 2018 3:00 PM To: [email protected] Subject: Re: [BITX20] Raduino v1.28.1 released for #bitx40 Hi Paul, For now this fix is

That seller is a rat, as he will not ship to PO box.And I only get mail at the post office here. I'll have to look for another seller. I cannot understand why some sellers exclude PO Boxes, as well as

grills? What grills? I could use several of them. The speaker from the Mocom has a grill on it, so only need an opening, maybe make it two part when the time comes. Wayne WA2YNE Imperial TX

Hi Paul, For now this fix is only applicable to v1.28. Do you have the same issue with v2? In that case I might have to implement the same improvement for the v2 branch. 73 Allard PE1NWL

Allard, Is this fix applicable to version 2.04? Paul KL7FLR

Hi, I've just released Raduino v1.28.1, download it from https://github.com/amunters/bitx40 In this release: * Fixed a bug that the PTTsense mod was not reliably detected on some radios. As a result,

Jerry I am not sure about those other spurs being taken out by Raj/Farhan's filter. The fact that they were unmoved when I increased my "filter" attenuation by 10 dB tells me two things: 1) They are

The PTTsense mod is required for CW operation. During start up, the firmware tests whether the PTTsense mod is installed. It was found that the PTTsense mod is not reliably detected on some radios,

The PTTsense mod is required for CW operation. During start up, the firmware tests whether the PTTsense mod is installed. It was found that the PTTsense mod is not reliably detected on some radios,

Will an insert of a 45 Mhz filter before C10 in the RX line help up the RX performances as well.That will not stop CW op. After all we have quite a large amount of attenuation from the 30Mhz Lpf throw

What version did you load. rOn

Indeed, however for the record I should have said mike? aka Push to Talk Jim

"ajparent1/KB1GMX" <kb1gmx@...> wrote: That's my whole point. It's why I say find the compression point under CW generation and don't go past it with peak SSB loads. A scope works fine for this.

What I did find is at 13.8V all on the 2n3904s in the power chain run very hot with no signal.? How hot 125-130 degrees.? Measurements had the first Q90 running at 38ma and for a low level sage

I got the W0EB/W2CTX sketch for my uBITX and found it a good solution for my 2-line display. uBITX will be used (if further stones are removed) for outdoor operations and I dont like a touch display

Tim, First anything on scope that is not time or phase related is a gross test, as apposed to fine grained test. That said if you see flat topping you have gone too far.? However there are other