开云体育

calling also but nothing heard. This week unlike the last 2 weeks I have my antenna connected. Don't ask. don, still listening

Rick, I'm saying that you really SHOULD! A little history: I originally had a .01 uF across the input audio and well, surprise! Then Kees slipped it in on his re-make so I tried again with the same

If there is no current drain, what shows up on the LCD? Is the back light lit? What method are you using to measure the current draw?

Dear Michael Thank you for your wise words. Now all I have to do is work out why there is no current drain. Andrew

You wanted wise ones, but I'll jump in till one shows up. The uBitx will want to see 50 ohms, ideally under a 2 to 1 SWR, though I suspect it will survive most anything if you power the IRF510's from

Don, please don't think I was questioning the experts, just was running out of options, suggestions, and like I said nothing ventured nothing gained and had tried everything else. Will always take

Thank you!! I tried that TWICE and got this screaming tone. Perhaps the third time is in order. I wonder sometimes if I am living in an alternative universe. Goes to show that you should always

Thanks Rick- ditto on the electrolytic. I tried a 1000uF 16v electrolytic at the board and didn't notice any effect at all. John KC9OJV

Finally, after a year or more of hand ringing and second guessing myself, I finally pulled the switch and ordered my uBITX! Believe it or not, it came down to the ICOM7300 or the uBITX. I picked the

I'm calling CQ on 7277. Hearing nuttin but noise! -- John - WA2FZW

John, Don Lawrence, others Interesting Outcome! Shielding was no help, replacing pcb with perfboard agc helped a little, but back to pcb. bypass's on 78L05 were .68 on input and .1 on output still no

Are you getting audio from the board ? wrote: -- Michael Shreeve N6GRG

I looked at the V4 schematic and the value for both of those caps is zero. This means there are no caps installed. V3 has the same lack of capacitors. So, he isn't using them. -- Michael Shreeve N6GRG

Two capacitors -C210 and C216- arr missing from my uBITX motherboard. Also, when I connect the board to 12V, the book says that the current drain should be 100mW. But there is no current drain att

Thanks Gordon, I've been looking around for this problem and just when I posted this I saw a similar posting from Gwen Patton just here !! OK, I will start shielding and bypassing :-)

double check you have a 4.7k resistor across Radiuno pins 2 & 3 and recheck all your ground connections -- www.bitxmap.com ( http://www.bitxmap.com )

That is classic radio frequency interference. I’ve seen it in my own unit—-, so start shielding and bypassing and keep it up, until you get it stopped. Folks who do digital communications get real

As soon as I speak in the microphone the display switches to "Band Select?". Both on a EFHW and a dipole antenna with low SWR. Except building RF chokes is there anything else worth trying - like a

Do not place that capacitor from Q1 base to emitter. That will make a dandy blocking oscillator. Pin 7 of U1 already has a bypass (C78). It's just not shown on the schematic. Rather try hanging a big

Gwen, I still suggest trying the ferrite on the Raduino wires. Your issue will probably go away. Does it happen on any frequency or just specific bands? I doubt the power source will matter. If you