开云体育

Excellent solution, does it also remove the thump?

Ade You will be interested to see that I now have my 3.5" Nextion Standard screen working.?? Just needs to be installed properly in the front panel. The hard work in upscaling graphics and

I am also working on a similar model of Modular approach. But I am working on a concept of Plug-in modules. I have already created some of the modules which when ready will be plugged in a Base

Mike, many thanks for answering my question and in great detail. I think I have some playing around to do. At least it will keep me out of mischief.? 73 Ade M0OJR

Check the obvious first. From the antenna input to the audio. So check first the stage from the antenna connector to the lowpass filter.

Somebody has already resized the graphics for the 3.2 inch version (by upsaling the 320x240 images.?? But so far, no other versions are available.? I imagine a number of other sizes will become

This may be a silly question folks, but will Ian’s files work ok on the 3.2 inch version? ?Ade M0OJR

Joe I'd be interested in what you will do with all that real estate on the 7"! Mike ZL1AXG

uBITx v5 (although it may cost a bit more with all those extra connectors) M -- Mike Woods mhwoods@...

Oh there's no doubt that as a disposable meter, they're fantastic. When I needed one the other day to help figure out what was going on with my daughters car, I hooked one up to a 12v accessory plug

Take a look at this post:? ?/g/BITX20/message/51448 where Allison suggests replacing all three of Q20,21,22 on the transmit side.? A bit surprising, but then we need a fair bit of

I've found this to be very handy for the

I might try using the MMBTH10 here too,? I have quiet a few of them... Which 3904 would we replace? Cheers.

OK, you guys are getting serious. I'm moving the discussion back into the power chain thread so I can find stuff later.? In post? ??/g/BITX20/message/51743? ?Allison mentioned

I had perhaps indicated that i generally tie the backlit of 16*2 to unregulated supply by increasing the series resistor. regards sarma vu3zmv Regards MVS Sarma jjpurdum@...>

Ok. Using the output of a dds generator and different attenuator blocks, to get the same audio out at 10m had to reduce att by 20db compared to 40m. So what section should I start looking for the

We're using the 7W TDA7266M chip and are pretty happy with its performance. Jack, W8TEE

Hi: I've built a few BITX rigs from scratch now and I'm starting to move to a modular approach using fabricated PCBs to make it easier/faster to build/mix/match the stages.? My audio amplifier

I tried a BFR93a (because i had some) for Q90 which seems to work OK.? glenn vk3pe

Hi Roxie, I have used the LA4425 AF amp in a home-brew transceiver, not the uBITX. It's a very simple part to use and seems to work very well. Very few parts required around it. Just being cautious I