开云体育

I called DHL and they told me to leave a note on the door with my shipping number and my signature. As it turned out I was home when it was delivered by a courier and no signature was required anyhow

This is a news bulletin from WA9AOE.? μBitX board was shipped today.? Order was placed on December 20, 2017.? Hope this helps others. Lee, WA9AOE --- This email has been checked for viruses by

Hi Ian, ?So what is the latest version of firmware? I down loaded 1.01 and installed it via Xloader, however when i turn on the uBITX it shows 1.00 on the display. Now I notice there is a version

makes sense now. thanks i never did a pcb so i was clueless. thanksa again glenn dave

Okay I will do that, and continue with wiring up while I'm waiting for the new chip Thanks Mike N2HTT

Should work fine with Allard's sketches. I believe with no modifications to the sketch if using a standard parallel display. Not a bad idea to move to an i2c display to free up some pins, but that is

Mike, Now break the 2822 and remove the pins one by one. Put in a socket. If everything looks alright then you can get audio from the volume control top lead and listen on an ampli speaker. Raj

Okay thanks Raj. It will bed a few days before I get the new chips, I'll review the board 73 Mike N2HTT

Mike, The voltage is fine, something else blew it. Chip cracking mean catastrophic failure.. Check for solder bridge short etc.. these boards are checked before they are sent out. Raj

My supply voltage was 13.8, is that too high? That is nominal 12v supply. I will check the chip orientation before replacing the Thanks Mike

Mike, That may happen if power supply voltage was too high. The chip may have been soldered wrongly - please check. 2822 is a very tough chip, I have melted a breadboard but the chip

Hi Brian, I am very interested in your HAB project. I want to do the same. Please forward me some details, links, etc. I have been following Andy in Australia with his solar panel Mylar party balloon

Maybe you should donate one of these replacement boards to Allard so that he can modify his latest sketches for it ? Will mean more sales for you... KC9SGV

Hello, I just received my uBitX and started wiring it up per the instructions. I wired up the power connector with the diode installed, and measured the draw from the main board, and it was high: 140

Will it work with the Allard sketches ? Bernie, KC9SGV

For us with no PC can we get them pre programmed that would be a big help chris [email protected]> wrote:

Nice work Nik. I will be ordering as soon as they become available. For v2, could you think of breaking out the unused analogue pins? / Gerry

Of course, Mike. But first I have to "clean it up" and translate comments, because they are in Spanish. I will start doing that and? I think I can offer the open source sketch for those who want it

AUD or USD, Nick? Bill, VK7MX

Okay I spent some time trying to understand the change. You sent 10k (103) resistor tapped to the paper. Replace that with the 100k (1000) near the input and that’s it right. Okay I will make the