开云体育

With the raduino you will have to enable USB and it'll switch the VFO to +12mhz offset instead of -12mhz offset. I did this on my BITX40 though I use the QRP Labs VFO. The principal is the same. You

It just came to me. it's something like "CQ Texas BITX40, or whatever state you want. Just like specific DX countries. Sometimes you gotta ask the question out loud to someone to figure it out for

So, how does one go about calling for near by contacts, or even certain areas of the country. Like, what is the opposite of CQ DX? My intent is to call for BITX'ers closer to me that I have better

Ok finally got the Vox board adjusted and hooked up the laptop power supply. I have about 19v on the PA and am getting about 9-10 watts out. Plugged in the computer this evening and was able to make

A good working solution : www.petefleming.com/bitx-bfo.pdf Works well and its for a rotary Joe VE1BWV

Nice project. ? Note that it runs under the Arduino environment. So Allard's sketch should compile on it with little fuss, run alongside the filters. WIth display and Si5351 breakout board, could

That is useless as i have a rotary encoder

N9ARZ Jeff Cummings Spiceland, Indiana? about 40 miles East of Indianapolis 135 foot end fed long wire. EM79gu

Thanks! Jack, W8TEE To: [email protected] Sent: Thursday, June 8, 2017 10:48 PM Subject: Re: [BITX20] Calling all Midwesterners. I am ... now. Vince. -- ? Michigan VHF Corp.? http://www.nobucks.net/

Here are the Midwesterners so far . . KG5KYJ, John, Oklahoma city, Central time zone. 18' NVIS Dipole. 24 Volt BITX40 KA8CSH, Vince, S.E Michigan (apx 30-40 mi N of Detroit) W8TEE, Jack, Cincinnati,

See below: To: [email protected] Sent: Thursday, June 8, 2017 7:17 PM Subject: Re: [BITX20] W8TEE TFT/VFO Board from FDIM talk Jack, Thanks for sending the boards. Picked them up today.. Nice looking

I am ... now. Vince. -- Michigan VHF Corp. http://www.nobucks.net/ http://www.CDupe.com/ http://www.metalworkingfun.com

I found this crimper and it seems to do a good job - search your favorite on-line mall for: "IWISS Dupont Professional Pin Compression Ratcheting Modular Insulated Terminal Crimper Pin Crimping Tool

Is anyone writing down the midwest people? Jack, W8TEE To: [email protected] Sent: Thursday, June 8, 2017 10:15 PM Subject: Re: [BITX20] Calling all Midwesterners. N0BHC, Bob, Savage MN, EN34hs

N0BHC, Bob, Savage MN, EN34hs

Hello everyone! Since I've moved on to an all band SDR qrp rig I've decided to offer up my built up Bitx40 with raduino. The rig is built into a sheilded Hammond enclosure, is running Allard's

Our groups Raduino Rock Star Allard has put together a package for us, read the instructions. Hear is the link. https://github.com/amunters/bitx40

Hi everyone I was wondering if theres a way to switch between lsb and usb so I cam talk and or do digi modes

I'm not talking about pins from ebay. If you bought them on ebay, you use 'em. Vince.

Good, you clip the edges of each pin, its fun, you can have all the ones I bought on eBay.