开云体育

At the moment of power up the display shows the version. The sketch developed by Farhan is version 1.0 Carlos CX8ABF Sent: Monday, May 22, 2017 10:58 AM To: [email protected] Subject: [BITX20] version

what version of the sketch is included in the kit for bitx40 as shipped terry gm4dso

i am still not sure that it is a relay problem. can you tell us what is signed on the side of the board as the serial number? - f

Bryan, You might as well replace them. I prefer Matsushita or Panasonic. Omron and other brands are all made in China! They cost a couple of bucks each on the bay! Raj

Yes that could be the ones it's very hard to read what on them One has no RX on one side the other no RX on both sides Tested out of the board with12v doc ok on Tx terminals but of on RX Bryan Sent

no Bryan Sent from my iPad

Yes I tried them off the board (extracted) and results the same Contacts made on Tx but none on both sides on one and one side on one on RX Bryan Sent from my iPad

Sorry it is Raduino board .Auto correction spoils my mail.

I am not facing click problem after inserting 7809 three pin regulator IC in between trx power supply and rajini board.and 7805 IC in the dds board is cool now.

Thanks guys.?? And thanks to QRPARCI.?? I must admit though that my first thought was that this must have been some sort of elaborate revenge operation for my April 1 FAKE story about Pete getting

The Raduino sketch itself does not fix the tuning clicks, but installing the correct si5351 library may improve the situation. It was found that the latest si5351 library version causes strong tuning

Contact made and order placed ! ? As it happens, the postal address I wanted to use was already in my list of Paypal addresses, so I selected that, without any problems. ?I last used that address

Thanks My version clicks as I tune through the frequencies. I can see no mention of any changes to this issue. Does the latest version do the same? peter Sent from Mail for Windows 10 Sent: Monday, 22

W1LY 59 ++ easy copy into WA9DOH 65 mi NW Chicago. IL/WI stateline cruisenewsnet@...> wrote:

Dave I can hear you as well. I came back to your furst calls but looks like the band might be going south. John. KG7UMN Sent: Sunday, May 21, 2017 9:23 PM To: [email protected] Subject: Re: [BITX20]

I can hear KG7UMN calling CQ occasionally, both via my bitx40 and the websdr radio in Sedona, AZ, but just too much noise... 73, Dave N6AFV

Sorry - I realize that I need to show my callsign in my signature - N6AFV, Carson City, NV

No luck again 7177 appears to have a net every Sunday night. I suggest we move the PST time QSO to 7181 if possible.

Well, I think I heard KG7UMN tonight on 7180 KHz, but unfortunately, the band conditions and noise level were just too bad, and I was unable to hear much of anything else. I saw on QRZ.com that

Oops, it looks like that link is not working. Maybe try this? http://m.ebay.com/sch/i.html?isRefine=true&sid=sunillakhani&isRefine=true&_pgn=1&_mwBanner=1