开云体育

I agree with Craig. Keep it coming. I want it in one place also, and if someone does not want to follow a topic, then just hit the delete button. The vast majority of what I have seen on this forum

To all, This is a frustrating subject. I want it all. I want it all in one place. I want it in a form where it is easy to find what I want. I worked in the AS/400 world for a dozen years.

I'VE ENDURED THE FIFTY (50) AND MORE MSGS A DAY.... BUT TODAY THE TOTAL HAS HIT NINETY TWO (92) !!!!!!!! READ THE BELOW MSG!!!!!!! INSTEAD OF DROPING OUT OF THE GROUP... I'VE DECIDED TO TAG ALL

Rob, Here are my Voltage Measurements before I replaced the IF510 transistor. I'll do it over and send the final measurements.. Chris N1CFB

Hello all. Like most of you, I have been getting many many Bitx Digests a day. Some are interesting, some not so much. They seem to fall into 3 categories. Bitx40 hardware, Arduino hacks, and 2 way

It might still be ok as an output.

On line 102 you will find: #define PTT (A6) which defines a symbolic constant named PTT. Because pins are initialized (normally) in setup(), either gloabl-search on PTT or look in setup() to see how

William, Great! that tells me the ADE-1ask is not a fake! Now I eagerly await further test results from you! Raj, vu2zap

Raj, 1-6 - 0 ohms 2-5 - .216v in both direction 3-4 - 0 ohms W4WHL wrote:

Yes, I have killed two of them one ones my fault when one of the input wires brushed the 12v line and the other I blamed on static as well. That's why I took the time to put a socket so I could remove

A 10T pot for tuning is not required, the beauty of the Rauino is the way it tunes like a shuttle knob on a commercial rig. A poor mans shuttle by Farhan, brilliant idea I must say. A 10T pot is

I was late to the party last night but called CQ a bit but no response. Sunday 01:00 UTC 7195 sounds good to me. AA4PG Pat

Lol silly me I did have the plug on backwards... fixed and no change. I had swapped the tuning and volume pot and plugged it in upside down. VFO? You mean the DDS? Two pin frequency output from the

Sunday 01:00 UTC sounds like a good time Are we going to try on 7.195 again +- based on open freq and qrm. wrote:

William, Please check the continuity of your ADE-1ASK again. 1-6 - 0 2-5 - Diode check both polarity should be same reading 3-4 - 0 My guess is continuity between these pins but not between

We are apparently lucky with not so much static , being in tropical countries. of course i had few PIC16F628Athat failed. but never adapted anti-static measures. Better I learn from your

Reprogramming didn't help unfortunately - It's really blown. I know these are sensitive devices and I always take ESD precautions. Nevertheless it became damaged somehow. I never used this input

let him re program and try . wrote:

Is it correct to say that A6 is PTT in the V1.08 sketch , So it should go high when ptt is pressed ? 73 luc ON2AAV

Yes, two others here in KC area have lost inputs A6 or A7 due to static. I think soldering to wire while still connected to the pin is the reason but I’m not sure. New Nano always cured the