开云体育

i will trace it again john,,that`s what make me wonder during QSO.,they told me i have very weak audio., 73` Sent from Yahoo Mail on Android On Thu, 23 Feb, 2017 at 4:21 pm, John Smith via

Ya got me licked. Do you feel like there is not enough audio signal being produced before it goes out to the antenna? If yes, then that's what I would have told you and everyone else. Did you say you

Hello john, I already did that,adjusting R136 and RV1 and it gives 5-6Watts output but the problem is that my audio is weak.replacing new emc make no changes,, Sent from Yahoo Mail on Android On Thu,

Try adjusting R136 a silver trimmer on the same side of the board as the PA near the corner. If you rotate it counter clockwise it will increase watts output. It's best to adjust it up to the point

Do you mean that you have low transmitter output? ?If so, could be that you need to bump up the gain at R136. ?See post?/g/BITX20/message/22112 (

I considered doing that. The biggest thing is that I want one of those mic cables because they coil up, and currently mine does not. Perhaps I just need to find a better c

Use a small plastic box that feels like a comfortable mic, and put the mic poking out of the face of it, and the button on the side. That one from Banggood has 8 pins. You would only need 4, two for

Once again Jerry, that was exactly it. I replaced all but the last "}" and it compiled. When I tried to highlight "{" on #617 it wouldn't let me. It would go to ")" instead. Does that mean there

Looks like you ripped out two bottom right curly braces. ?You should only rip out one of them. ?Compare what you ripped out with what I ripped out. ?And think hard about which left curly brace

Hey everyone, I'm looking at options for a "real" microphone and ran across this one:

Hello ?How to fix weak mic audio output? Sent from Yahoo Mail on Android

And we never heard from him again. I think Jerry deserves a gold crown for his patience, and generosity for helping others and going to the post office 90 miles in the snow and ice uphill both ways.

Ok, I copied the whole section and replaced the whole section in the sketch. And got the same error. Here is more detail- after turning line numbers it highlights in pink line #617. Here is the line-

Any bets that it's blinking at one second intervals? Some vendors load the Blink program that comes as a sample program with the IDE as it gives visual confirmation that the uC is working. To test,

I just completed my Bit-X 40 kit and when powering up I have a blinking red light on the Raduino board. I also get a clinking noise in the audio whenever the light flashes. ?I also have no numbers on

John Smith, Did you see this note in my follow-up email the next morning: Sounds like you might be missing the final "}". You said: ? ?" And I was just inserting the new lines between original lines

Hey, you got it. Hooray! That sounds about par for the course...live by the computer, die by the computer. Unfortunately, there is too much faith out there among everybody in the power of technology.

Got a note in the mailbox Saturday saying?RN187017248IN?(ordered Dec 23)?was at the PO, but registered mail so had to sign for it. ?They close early on Saturday, Monday was a holiday here

I gotta show ya how much of a noob I am. I started with copy and pasting Jerry's code into mine with the tune input pin change because I fried it in the beginning, and got errors. Then went with

Works for me Sent: Wednesday, February 22, 2017 7:08 PM To: [email protected] Subject: Re: [BITX20] Flutter Fix That would work, too. However, my preference is to put the URL and version number as a