开云体育

OK the hardware version is v3, when you turn it on it says which firmware version. Did you just buy it from the manufacturer? Then I think it might be v3.021 or something similar. If you have a spare

v3

Which version? -- Gyula HA3HZ

I have not familiarised myself with this new one, but a common problem is the barrel jack input......ensure you have the correct centre pin sized jack or you wont get connection.....so easy to get

Good morning all, I have been interested in the SDR rig and finally picked one up yesterday. I looked up the manual, watched a few videos but cannot figure out a few things. #1 when i touch the KBD

Uploaded fine ... but shows up as v1.04

USB-C with PD are a better solution as they are less likely to be producing noise. However, you should note that the power bank has to be big enough to provide 3 A @ 9V.

Hello Ragav, Thank you for preparing the new manual. For document control purposes, PLEASE place a Revision Number such as V1.0 and a DATE, such as March 30, 2025, on each issue and keep that

-- Glen, WB4KTF, Austin, TX

Try this https://github.com/afarhan/zbitxfrontpanel/blob/main/zbitx_front_panel_sw.ino.uf2 [email protected]> wrote:

Couldn't download zbitx_front_panel_sw.ino.uf2 from HFSIGNALS page. Downloaded code from zBitx page.- zbitx_front_panel_sw.ino.uf2 dated 3/30 9:15 AM. Xfer to zBitx - no response (stays on gray

Yes, drive is set to 100 and I am using the native application. The voltage coming off the barrel connector of the included battery holder is 7.56(display shows +7.4v) with 2 brand new fully charged

Seems like a little work with a volt ohm meter would bring clarity to lots of these situations Gordon kx4z

I watched the video you made. I would try some things. You should know that the USB cable to the CAT connector only powers the screen, not the raspberry pi. Therefore, it will never turn on. I would

Ragav, Yes, I can download now.? Thank you! 73 Evan AC9TU

D'oh! The sharing was restricted earlier, Evan. I've changed it to public now. Can you try it now? 73, Ragav

Ben, Can you confirm that the drive is set to 100? Are you transmitting FT8 from the native application or are you using a third party program like JTDX? Can you please confirm the input voltage and

Hello Ragav, I tried downloading the zBitx manual but was told I did not have access.? Did you intend to restrict access? I did request access through the pop-up web page. 73 Evan AC9TU

Hello folks, The zBitx user manual is available for download on https://www.sbitx.net/index.php/zbitx-user-manual-download/ If you are unable to find what you are looking for, please send us an

Mike, We haven't received your email in our inbox. Can you please resend it to sales at hfsignals dot com and also mark support at hfsignals dot com on CC for good measure. I've raised this issue