开云体育

Sent: Saturday, January 25, 2025 8:40 PM To: [email protected] Subject: Re: [BITX20] sbitx dev ic2bb address failed at 68 Why are you sticking with the old version? The current 64-bit version is

Hi Bob, If this is an sbitx, the current requirement when transmitting can exceed 6 amps. ?This depends on the drive setting. 73 Evan AC9TU

Thanks Gyula, I may have found the problem, but only may. It happened when I used a bienno and with a wall wart (2 amp). I switched the power supply and it now works. I need to check how many amps the

At times, the RFI keeps the relays on. Check that the swr is lower than 2.0 wrote:

Bob, You'd need to verify that the dimensions will work for you/your radio. 32 mm diameter knob, 13 mm deep. These fit 6 mm shaft diameter. I have not used these, but two examples from

Yes, a sticky relay also occurred to me. However, It only gets sticky after long transmissions. However, I will definitely check that out! Thanks. Marc N4DR

Choose a nicely sized washer & glue it to the edge of the front of the dial - use epoxy or maybe super glue.? Antique Electronic Supply has a very good assortment of knobs, they may have something

Have you selected the key? There are 3 options. The key has a voltage of 3.3V, which is connected to the RPi, so the key should not introduce voltage into the device! -- Gyula HA3HZ

When I use a CW paddle the radio power goes out and it shuts down. I have tried a Bienno and a AC power supply with the same results. Also tried two different paddles. Has anyone else experienced

I would like to have a detent (I think that’s what it’s called) to make spinning the frequency knob a little easier with one finger. Any recommendations? -- Bob NZ2Z

The Zero 2WH has a header pre-installed for about $3 more 73- Bdale, KB0G

And here is the one with headers.. https://a.co/d/fYeFf0q I will try to get a picture for you. -JJ

You can buy the Pi Zero 2W with header pins presoldered.. Here is the connector you need. https://a.co/d/4b0xhj4 -JJ

His comment is not visible on web based viewing. I can see what he said on my email client because it? seems to be an image and not text.. a bit weird. Raj

Just went to buy a Pi Zero 2W but they are sold with no connector.? What type ofconnector and how does it plug into the radio?? Maybe a picture? Ron

There is nothing to be gained in moving to pi5 except of course twice as much heat. You will neither receive more signals nor transmit further. Unless a new mode comes out that needs LLM grade

Sticky relay?

Hi Jens, You're not adding anything to the conversation by simply copy-paste'in another members post! And just to inform everybody else that might think I'm being rude: You have done it several

I have recently noticed a problem with transmission on my uBitx V6.1. When I transmit for long periods, the unit seems to hang up in transmit mode. I note on my wattmeter that there seems to be a low

Why are you sticking with the old version? The current 64-bit version is 4.301, which you can install on a new uSD card. Link: *sBitx 64 bit v4.2 - ELF* (