开云体育

Again, away from my sources, but my memory is that the library I used for pico (earle phillhover see link in master header library) mapped Po’s to axx and dxx. By using xx as a PIN number it knows

What power supply are you using Don? In my use, I have v2, which I supply with 12.5V and have a current limit of 6.3A. Yours is v3, then you can use a higher voltage up to 13.8V. If I had it, I would

According to the definition of the audio power amplifier: LM380 2.5W Audio Power Amplifier, so 5W power seems adequate. -- Gyula HA3HZ

My recently purchased sBitx V3 is not receiving signals on any band....just hearing the noise floor. On 20 and 17 m., I am hearing something like a heterodyne across those bands. HF Signals sent me

Thanks.. Now we know it is an 8 ohm, 30mm by 80mm speaker. I measured the hole spacing and came up with 19mm by 74mm.? I can try a smaller speaker and 3D print a bracket/adapter plate.. Now I have to

sBitx V3

You can try the 64bit version on another card without changing the original 32bit version, read here https://github.com/drexjj/sbitx

On Wed, Jul 24, 2024 at 02:30 PM, Don Trinko wrote: > > thanks; i am not having any problems so i think i will stay with the > factory firmware.? Don w8ptb > > > > It's satisfying if it works

thanks; i am not having any problems so i think i will stay with the factory firmware.? Don w8ptb

Good morning, what kind of equipment is it from? Scott [email protected]> wrote:

Another method, with the help of google, is to type in the terminal: *getconf LONG_BIT* and you will find out from the answer. more info: 5 Command Line Ways to Find Out Linux System is 32-bit or

The manufacturer still ships 32-bit. If you want 64-bit, you have to do it yourself. -- Gyula HA3HZ

how can i tell what firmware my v3 has installed? it is new and i bought it from Gigaparts in the usa

Someone already asked and as I recall the answer was LCD TV speakers. Based on its size, it is a rare version, because 30x70 mm is the typical size. But it's 30x80mm. But I found something worth

Hi, I'm new to the group, and got my V3 just last week.. and now time to fiddle.. First I made a copy of the internal SD card, then saw the issue with the time.. until I found this solution... Many

I have a customer who has a bad speaker and need a replacement.. The only identifier on the back is VG6527. Does anyone know where to find a replacement? Thanks, JJ

Hi Jeff, I!! Remind yo nex week, I’ll leave another post here. Thanks, I really appreciate it. Robert

Also change your last line to: *tx_on(TX_SOFT);* from sdr_request("tx=on", response); -JJ

when you recoded the kd8cec for the pico did you use pin numbers or gpio numbers ? as I am tring to follow what you did

is it possible with the work you did on the kd8cec we can do the same for the ubitx v6 code and pport it tou work on a 3.5 I have and recode it for 2m?