开云体育

The CALL field is used to log your QSO callsign for the logbook.. The wipe button works for me.. To open the log, use the SAVE button. -JJ

I have been running 3.027 and would prefer using the web interface except for a few things which I can’t figure out. 1. When I try to enter “CQ POTA” in the call box, it doesn’t accept the

Hi Farhan, My request would be to get the code compiling with a higher warning level and to fix the potential buffer overruns. I have noticed that you state a coding convention which is good but then

Thanks everyone. I've ordered two different types of speakers and will share results on performance and fit. I could not find an exact fit and will have to design a holder for the speaker. -JJ

although out of stock, I used this one when I created my 3d printer case. Think it’s the same. https://a.co/d/jbxIarR 73 mark -- AJ6CU/7 KD8CEC 2.0, Nextion Screens,? and open source uBITX

Thanks for posting your activation. I will try to contact you with 10W uBITX V5. Bob WB8BEL Sent from Bob’s iPhone

Im down for that. Haha. I will check my calendar and see if I can. Mine is currently a little bit “offline” but it should be back together by Saturday. WK4DS [email protected]> wrote:

I have scheduled a POTA Activation attempt for this Saturday starting at approximately 10:30 AM EDT (1430Z) on 20M SSB in the vicinity of 14.280 MHz (then later shifting to CW at about 14.065) using

Garrett, you reinvented the wheel. No external rig is required for sbitx to work in wsjt-x or other digital modes. For this, use the W9JES FD image and use an external hdmi monitor so that a lot of

I sat down and took a hard look at the microphone and even installed the element that Gordon recommended and it still wasn't working. I started looking at the signal and found it just didnt have much

How about being able to use the external headphone and mic jacks while using hamlib net to key the radio? I am trying to use a widows computer to run WSJT on and it works other than it will not use

I have tried it but it has not worked with two microphones that I brought, I will try the third one to see if it works

I would like to see an additional output port for an external speaker.. and maybe a little bit more "spank" in the audio output.. maybe it is my ears, but I feel it is a bit soft. I just got mine,

I have a MFJ-939 atu and was wondering if anyone has gotten one working with the sbitx v2?

After about 100 reprogrammings of the ATTINY85 and getting tired of straightening bent pins every time I pulled the chip off the plug in breadboard.? I decided to do something about it and built a

Maybe try this one: https://www.parts-express.com/Dayton-Audio-CE70-30P-8-1-1-4-x-2-3-4-Full-Range-Driver-285-119?quantity=1

Thanks for the comments about the power supply and possible other audio related problem. I am also consulting with HF Signals. They asked me for some videos of what is going on. They also suggested

I have a 4.1 so that will be nice , I will have to look at the code and see about what it will take for 2m/6m port. as we have been developing the 2m and 6m boards [email protected]> wrote:

Hello, I am Testing the tx part, the rx works well, I am using the headset microphone of a cell phone but it does not measure the signal with the oscilloscope. If I remove the mic, with the mic

Accidentally discorded my first reply. To summarize - frequency management is in si5351.ino. It is pretty dense and should be rewritten. It clearly suffers from incrementalism and lack of a strong