开云体育

Garrett, you reinvented the wheel. No external rig is required for sbitx to work in wsjt-x or other digital modes. For this, use the W9JES FD image and use an external hdmi monitor so that a lot of

I sat down and took a hard look at the microphone and even installed the element that Gordon recommended and it still wasn't working. I started looking at the signal and found it just didnt have much

How about being able to use the external headphone and mic jacks while using hamlib net to key the radio? I am trying to use a widows computer to run WSJT on and it works other than it will not use

I have tried it but it has not worked with two microphones that I brought, I will try the third one to see if it works

I would like to see an additional output port for an external speaker.. and maybe a little bit more "spank" in the audio output.. maybe it is my ears, but I feel it is a bit soft. I just got mine,

I have a MFJ-939 atu and was wondering if anyone has gotten one working with the sbitx v2?

After about 100 reprogrammings of the ATTINY85 and getting tired of straightening bent pins every time I pulled the chip off the plug in breadboard.? I decided to do something about it and built a

Maybe try this one: https://www.parts-express.com/Dayton-Audio-CE70-30P-8-1-1-4-x-2-3-4-Full-Range-Driver-285-119?quantity=1

Thanks for the comments about the power supply and possible other audio related problem. I am also consulting with HF Signals. They asked me for some videos of what is going on. They also suggested

I have a 4.1 so that will be nice , I will have to look at the code and see about what it will take for 2m/6m port. as we have been developing the 2m and 6m boards [email protected]> wrote:

Hello, I am Testing the tx part, the rx works well, I am using the headset microphone of a cell phone but it does not measure the signal with the oscilloscope. If I remove the mic, with the mic

Accidentally discorded my first reply. To summarize - frequency management is in si5351.ino. It is pretty dense and should be rewritten. It clearly suffers from incrementalism and lack of a strong

Again, away from my sources, but my memory is that the library I used for pico (earle phillhover see link in master header library) mapped Po’s to axx and dxx. By using xx as a PIN number it knows

What power supply are you using Don? In my use, I have v2, which I supply with 12.5V and have a current limit of 6.3A. Yours is v3, then you can use a higher voltage up to 13.8V. If I had it, I would

According to the definition of the audio power amplifier: LM380 2.5W Audio Power Amplifier, so 5W power seems adequate. -- Gyula HA3HZ

My recently purchased sBitx V3 is not receiving signals on any band....just hearing the noise floor. On 20 and 17 m., I am hearing something like a heterodyne across those bands. HF Signals sent me

Thanks.. Now we know it is an 8 ohm, 30mm by 80mm speaker. I measured the hole spacing and came up with 19mm by 74mm.? I can try a smaller speaker and 3D print a bracket/adapter plate.. Now I have to

sBitx V3

You can try the 64bit version on another card without changing the original 32bit version, read here https://github.com/drexjj/sbitx

On Wed, Jul 24, 2024 at 02:30 PM, Don Trinko wrote: > > thanks; i am not having any problems so i think i will stay with the > factory firmware.? Don w8ptb > > > > It's satisfying if it works