开云体育

It is on the native UI as well. wrote:

Just use the button on screen. It think it shows up at least in the web view. Gordon KX4Z

Aaron, You could wire one up to the mic Jack or you could use the TX feature in the sBitx software. Joel N6ALT

Adam, I assumed that you were using the stock firmware.? In addition to the KD8CEC firmware, did you change the display to a Nextion?? ?The KD8CEC firmware only works with a character display or

I'm considering adding a microphone to my enclosure as a back up feature. There have been a few times where I go on vacation and either I forget the microphone entirely or the microphone breaks. How

Thanks Dean, I think I have gone through all your posts on the sbitx. Also commented on your blog I am at work, when I get home this evening I'll check everything again. Last night, I downloaded the

Thanks Evan, I didn't have access to the source code. And I'm on travel right now The SBITX software works perfectly with the MIKROE? prototype board and the SI-5351 module. Reference all of my

Hi Evan, Thank you for your quick response. I loaded the KD8CEC v1.20 firmware and could not find the "Setup BFO" setting on my radio. 73 Adam SP5AWL W dniu 21.03.2024 o?09:58, Evan Hand

To clarify Dean's statement, the audio codec and the Si5351 are on different I2C buses.? The sbitx uses a Wolfson WM8731 codec on the Raspberry Pi system I2C bus (GPIO pins 3 and 5).? The RTC and

Hello Adam, Since you replaced the Raduino board, the issue is most likely the BFO and frequency calibration.? Here is a video from Ashhar Farhan on how to calibrate the

Hi,I made a short circuit and damaged Raduino, I couldn't change the band and frequency. After replacing Raduino and loading the firmware, the display started working normally, but there is a problem

It looks like a wiring error with your si-5351. ?The si-5351 is on the bit-bang I2C bus and goes to different pins in the Pi. ?Check the schematic for the connections. ? If the si-5351 and MIKROE

Can you attach the hw_settings file that is in the data folder?

I just received my sBitx v3 and it is a major improvement compared to the previous one I had and returned. I like the new software and the new GUI. CW is working great and so is ft8. However I have

Yes, there is a 64-bit version that can be installed on 64-bit Bookworm. Use the following command in the terminal after downloading it from the GridTracker Download page to the Downloads folder: cd

The stock Pi image is the one you downloaded. It is the 32bit version from Ashhar. Myself and others have created customized versions of the software and 64bit offerings. -JJ

Show off! ? Scotty WD4PYT wrote:

Aaron, that is a nice box. The printed V3 box OD is 10 1/4” wide, 2 ?” high and 5 7/8” deep. Hopefully this will give you an idea how your proposed project box stacks up to the printed box.

I have a Bitx 40, bitx 60, uBitx 3,4,6, SBitx DE, V2, V3 and last but not least a Antuino. Nine items for me. Joel N6ALT

Hi, my opinion only, but fins on the inside would be fine if you had some means of forced air movement. A small efficient fan on one end and holes at the other. Obviously that would add power