开云体育

Hi Charudatt Where did you get the 40MHz xtal filter from? I’m guessing that’s what the blue add on board is. Thanks -Jerry KN6BJK

Hi Mark. Is the owner/group root:root for the calibration file? -JJ

Looking for some guidance here... My touchscreen calibration is off to the left and slightly high. So to hit the IF button, I actually have to click the Drive button. I have installed

I would think that a valid update for sbitx would be a wait screen while the computer finishes boot up, keeping it in pause until the final boot completes. How to accomplish that? I have no idea! ?

You’re not the first one to offer me that advice. Hmm must be a thing. Thanks Scotty!

I have noticed, on mine, if I open the app too soon after boot up, it is just pulsing static. If I close it and reopen, it starts working right. I guess count to 10 first? Scotty

Okay, that was odd… so I just did the routine apt update and upgrade dance… After a reboot it started to work.. strange

That's a nice looking board.? I have not made PCBs like that.? ?I've started to learn how a couple of time but get a little lost when going from schematic to layout. And the parts choosers don't?

I have them for 80 though 10 for the truck, and pairs for 20 and 10 dipoles. The ones for 40 and 80M I tune them different than instructions. I keep the whips full length and slit the heat shrink over

Oh de W2JON btw

Hey gang I've been anxiously stalking DHL and today the sBitx came! I hooked it to my Astron which is outputting 13.8v .. first start up I opened the sbitx software and hear just cracking static..

Thanks - I'll give it a go over the weekend and report back.

Did you know you can slide your finger left or right on the bottom of your sBitx? V3.02 screen down by the TX RX buttons and it will do the the same thing as turning the MFK? I don't know whether

Hello Dean, I am building one and am stuck in the analog section , signals not passing thought Sharing a pic of my Board, Its only the exciter board without an Audio Amp as of now. Thank you for

I’ve got good performance using two ham sticks per band in a dipole configuration. ?It takes a while to tune them but they both work fine. ?I work primarily digital modes on both 40 and 20 meters.

Or sold. I haven’t been successful with any computer based anything.

Fantastic! I hate it when things don't work, but it sure is satisfying when something gets fixed. =Vic=

I should work. Just set the correct ALSA levels and knobs. - Rafael

Among the data on github, there is a schematic where you can find the keyboard connection. Check if this is ok. The device is an RPi-controlled sdr radio, so the RPi must log in first, and then,

I have a mic and audio processor with line level output. Is there any reason I can't apply this directly to WM8731 pin 19 directly - bypassing the mic amp circuitry? I will use a 1:1 transformer to