开云体育

Joerg That would make sense, but so far you and I seem to be the only ones having this exact issue. Mine is the latest software (updated Friday) and software would affect everyone using that version.

Where is the signal s-meter display on the sBitx v2, I can only see a waterfall? thank you.

Run "git log" from sbitx directory wrote:

How can I tell what version of firmware my radio is using? Thanks Wd8axa

Well, there was the change to the location of the threaded inserts for the PA transistor heatsink, correct? 73, Dave? AB7E

I have the same problem: power OK on CW and two-tone mode but nothing with the MIC although the input to the WM8731 looks OK. So my conclusion is, that it must be somehow software/ configuration

Have tried different power supplies and lipo batteries with same results reflashed firmware have rf chocks on power line as well….will check ground points inside case is next step Sent from

The sbitx does have spurs but they are all well below the band noise (when the antenna is connected). If you have spurs, you might want to check with a different power supply. There are no hardware

hello I got a v2 model from a ham that was bought on 4-17-23 built..I am curious if any hardware changes were done to the v2 for the hamvention release..Mine seems to have a lot of birdies in the

Thank you Rafael, As I'm not so familiar with Pi software. I don't know what to do with the commands form the Github Link? If it is just to copy and past to the Pi command prompt, It OK. Other why I

And, comment the line in sbitx source that calls fldigi, or just close it.

Try with this asoundrc (/home/pi/.asoundrc) https://github.com/Rhizomatica/hermes-net/blob/main/system_services/alsa/asound-sbitx-hermes.conf Use the "default" device at 48000 of samplerate. And

Gyula & Salim, Just check my test piece which was at 90% gain and decoding. Even at 100% if worked fine. So Salim must have a high gain antenna to over load. Raj

Gyula, Thanks. Yes you are correct. The RX gain was too high in the screenshots. 73 de salim vu2lid / n8li

Salim, just a suggestion for FT8 settings. The AGC must be switched off so that the received signal is not amplified, then your answer is correct. It can also be seen in the waterfall that you are

Jack, thanks for the information. When I take the time to tear apart the v2, I'll check out the Bias as well. I didn't have to change IRFZ24s, I just wanted to do the May 4 settings. The success is

Thanks Raj ! After a few tries it worked :) 73 de salim n8li / vu2lid

Hi Salim! Sometimes a hard reboot solves the problem. Raj, vu2zap

Hi, I am trying to see why FT8 decoding doesn't seem to be working on my v2 sBitx. Time seems to be synchronized. I can also see several fldigi -i processes running (please see the screenshot of a

I'm Trying to configure an Digital software like Qsstv or WXJT, (After closing the FLdigi that start automatic with the Sbitx). I configured the sound In/Out the same as In FLdigi, But no audio came