开云体育

In principle, yes. I am back porting JJ and gang's 64 bit distro and all the software that it carries to zbitx hardware [email protected]> wrote:

The zbitx is a sandwich of two boards. We just redid the front panel oard to increase the height by 5mm. This will allow us to use a far better speaker than the tinny speakers that are prevalent in

Very good response.? ?I wish you the very best.? Doug, KI6DS

I really look forward to this, I'm going into zBitx withdrawals, there has been very little discussion in the last few days. I know, I need to get a life. Joel N6ALT

Oh yes, my name is Brandon [email protected]> wrote:

W9blw, Need to get your name on here!? I might have to look it up on QRZ! The silver box is the 3 amp Drok

JJ, I'm not very savvy with Linux, at least not to the point of figuring out how to get a piece of hardware working on it. I had to ask my partner to help me get my Ambeserver set to connect headless,

According to PA7LIM's website, AMBE3000 USB devices do not work directly on Linux. I have a DVStick 30 which works on the Windows flavor, but not on Linux. I built and compiled AMBEserver as well, but

We took close to 400 [email protected]> wrote:

Hi Barry, I'm no expert so just sharing my experience.? When i was first playing around investigating i had the radio open and noticed a huge change in hash noise at the target frequency just by

Guys, on the shielding of the display ribbon cable, how many ground connections were used. I wrapped mine and grounded the shield at the display but not at the PI end due to lack of an easy ground

Just incredible work, wow...? few questions for you, the silver box with yellow red and black wires at the bottom, what is that, replacement buck converter?? can you send me a link to what you

I found this link: https://itshamradio.com/bfo-tuning-aid-ubitx/ I have not tried using it, but it connects to my laptop mic and displays the spectrum. 73 Evan AC9TU

Hi Peter, The page displays, but the spectrum analyzer does not appear. I just tried it again, and it has the same symptoms. 73 Evan AC9TU

Hi Evan I had watched the video several times when I first tried setting up, but obviously had forgotten the 'up to 15secs' period. I will try that, it did seem strange that only one sub-routine was

Final shielding for me.

Thank you for introducing your work and for these words you wrote here: -- Gyula HA3HZ

ps,: reverse voltage when it reaches and exceeds the set current the reverse bias: it does not reverse the voltage, but reduces it to the extent that the current consumption exceeds it. -- Gyula

Gordon, I don't have a Zener or suppressor on the gates of the FETs. I think about this differently and only limit the input power for protection. My power supply is a current limiting and has a

Puzzled still how I blew an IRFZ24N (just one -- the other appeared fine) in a highly modified V2 which has huge zeners across the gates to ground which have been shown with oscilloscope photos to