开云体育

I have the Sbitx V2 #108 for sale. Purchased at Hamvention. $325 w/o a Pi, $375 with the Pi installed. Plus split shipping. Also comes with 3D printed legs/stand and the HDMI plate that allows easy

Carl, That's because it boots into the RasPi OS. It has the sbitx info in the 2nd partition which is not readable by Windows. Put it in the Pi and boot up the radio. Hank W6IR

I finally got a new RPI installed and installed the RPI iOS. The link that HF signals gave me for the sbitx_iimage.rar extracts to be identical to the rpi iOS can you provide me a link to a valid

Mark, The bandwidth is limited by our crystal filter. I couldn't make it wider than 25 KHz. If, instead, we had used phasing method, we could have achieved a full 96 KHz spectrum display. I discarded

The sample rate appears to be 96 kHz, but the bandwidth is only 24 kHz. Shouldn't it be 48 kHz, half the sampling rate? Is this due to the overlap-discard processing? -- 73, Mark, N8ME

Impressive that the harmonics are NOT a problem.? ?I don't remember ever being much worried by them on my DE, either. I've seen those low low frequency spurious signals a lot.? ? I think changing

Gordon, Here are two spectra for 80 and 10 meters.? 10 seems to be the worst, with both lower-than-set frequency spurs and a higher 3rd harmonic: Based on the latest measurement, I may have a

Kind of old-school.? No rotary encoders or si5351s here.? Just L and C for the VFO.? https://soldersmoke.blogspot.com/2023/10/dial-scale-linearity-spreading-out.html 73? Bill N2CQR

I would like to get a project enclosure and have a cable out the back for the microphone cable on the radio. Have 2 jacks, one for the electrict microphone and the other for PTT. It would be nice to

You can certainly use an amplified CB mic. I’ve done that with Heathkit vacuum tube transmitters successfully. However, it’s probably considerably cheaper to just use the element that I found

Aaron beat me to it. A Mic with a preamp or I had co sidered just building a simple amplifier circuit with an adjustable gain pot and wiring it between the mic input and the circuit board. Either of

Rose, I’ve never tried the side tone for voice. I don’t know anything about that If I crank the mic gain up as high as you were saying, I’ll have terrible distortion. With the stock Mike

Yes, that is what Farhan does to get the mikes for the hFSignals supplied radios.

At the request of Ashhar I'm posting this here. Original message:

Mike, Thanks. I'm using it as a learning tool. Mark

I have a cheap dynamic mic and I'm trying to convert it to an electrict and wire it up for the uBITX / sBITX and use it with my mic boom. I use a mic boom and PTT pedal with my Elecraft K2 and I

Mark, I've been looking at all the work you've done in your sbitx-n8me repository at GitHub. You are doing a really great walk-through review and cleanup of the source. I can't keep up with you, but

Hey Evan, could you publish some of the results you’ve gotten from your developer edition for a comparison? Maybe figure out what is the worst band, and show how good even that still looks? I

I am REALLY happy with my -24DB cartridge homemade Mike. The Sbitx needs a good bit of audio signal input. I think this is a great chance for a cottage industry to develop selling these mics and

Thanks Evan. Yes we need confirmation. One way or the other. Either I’m doing something wrong, or my unit is a complete fluke, or there’s a problem! I’m not sure why anyone would bother