开云体育

I decided against trying Loctite, Raj. Mainly because the classic method of persuading Loctite to loosen its grip is to apply localised heat. I don't know just how hot the heatsink might get but that

Started a new uBitx V6 build using Triumvirate Skonk Worx’s (TSW) new software. I think they have a good plan using two pins to handle dots and dashes instead of 1 pin with various voltage

No, I just saw your post and thought I'd jump in and say Hi and show how the encoder pin look. I meant to say RP pins, but didn't out of habit. Jack, W8TEE

Hello Jack, Good to hear from you again. I am not sure what you are referring though, as I don't have anything that currently uses a Teensy. On the sBitx, I assume the switch on the main tuning

I agree, the function encoder might be a better choice. Something else I would like to see, is the function encoder after say 10 seconds return to the it's primary function as the AF gain or some user

Thank you for sharing your experience. -- Gyula HA3HZ

After running the new boost converter I got from Amazon with the 4.7uH inductor on it for the last three weeks I have noticed a lot of wide band interference on most bands that wasn't there before

Hi Joel: Long time, no see! You are right. At the moment, the encoder switch (if present) is unused. There's a very profound reason the encoders don't have switches: It what I had on hand at the

It might be better to have a long press on the function encoder to lock the entire screen. This will be better as you will not accidentally slip the tuning knob while pressing the button. Locking the

The switch on the main tuning encoder doesn't seem to have any function assigned to it, perhaps a long press of that would work, leaving the short press for something else. Joel N6ALT

LoopMasta, I do not have a V2, so I can not give you actual voltage or oscilloscope waveforms.? Reviewing the schematic and interpreting from my V1 De, I would check that the TX signal changes from

Maybe a press and hold turning knob to lock/unlock the VFO. I am not a software person but am having fun playing with my new toy.

Hi everyone. Can somebody please send me some test data so that I can repair my sBitxv2 board? I need to know the gate voltages at Q22, Q28, Q29 on rx and what kind of signal I should get at C212 if

Raj, The loose clamping is a mere hypothesis. We haven't ascertained it yet. We can look at some heat resistant epoxy if it proves to be the case. It is an oddity if open design that you tend to only

How about Loctite or threseal or similar Farhan ?

In mine black wire is ground.. Raj, vu2zap

Farhan, When I run the v2 software and leave the web interface up on a second HDMI monitor attached to the Raspberry Pi, the waterfall on the gtk interface running on the DSI touchscreen stops.?

If you been thinking of trying KD8CEC out, hard to beat this deal. Just search for "nextion 2.8 discovery" on Amazon. Even though I have been a proponent of the enhanced or intelligent versions, the

Ashhar A couple of weeks back I reported one of the heatsink clamp screws on my V2 (serial #12) having arrived from Hyderabad still firmly attached to the tapped spacer but that the spacer itself had

Very interesting.? Thanks again! Take care, Dave?? AB7E