开云体育

Looks really sharp. Thanks for posting.? Can you provide a source for the?flight case that you used?? Thanks & 73 Dan

Imho, many hams have ceased to operate the ubitx until they make the mods to be fully compliant. Others just like to test the board to learn and experiment. Last weekend many active ops were busy for

Yes Vic and I had a nice qso. I listened on and off after that but quit when I was getting an AM carrier.? Vic said that he used his bitx40 as a mobile rig at times. I found that very interesting.

Thanks Tom. I recently printed one of the paddle keys from Thingiverse and one of the uBitx mikes. One thing I did that was useful was print a fly fishing reel and I have installed a 66’ long wire

That is a very nice design. The outer case looks like the case I bought at Harbor Freight. I was thinking about mounting the uBITX and a Raspberry Pi in it, also. I just bought a 3D printer, I may go

On a windows 10 machine using a v3 ubitx. I'm trying to use CAT control for my ubitx?with wsjt-x.? I select FT-817 as rig type, set baud to 38400 and COM3 (after loading CH340 driver).? I see: tx >

I’m not sure if you guys found the correct support for 3.2 or 3.5 or larger but I found the right files by searching. I can try to find the link if you’re having difficulty looking, but the right

Check out this link: https://ubitx.net/2018/07/16/nextion-3-2-and-3-5-display-firmware/ Not sure if this is the file that uses the full screen, or just recompiled with the higher resolution set

Very nice! Even room for a Coke and a sandwich! Jack, W8TEE

Please excuse my ignorance but i am a complete newbie ,is the software available for use with the Nexion 3.5 inch screen as i can seem to find it for other screen sizes but not this one.The screen i

Yes, listened at 3PM EST (2000 GMT) and heard K0MBT calling CQ. We had nice chat, BitX40 to uBitX, about 843 miles. Times for the weekly 7277 Sunday meet are 3PM and 7PM local time, although that

My newly created uBitx Go-Box - 3D printed and inserted into flight case. If you want more information and pictures head over to https://www.thingiverse.com/thing:3239609 Working to install a

My bitx40 is on the original plastic box... Because it's not really end it. I'm planning to update to a metalica one. My ubitx has a aluminum container. Shielded and hard protected. Carlos 73's IK1YRA

What time was that in GMT?

my ubitix v.3.0 worked fine but since yesterday on the lcd i have only "ubitix and v.080" no more frequency !

Andy, I've always used 450degF with my smd stuff and have never had a problem soldering anything. I don't use a pointed tip but one with a small flat on the end, a *very* small flat. Don't remember

I'm using one of the 12V outputs from an ATX power supply that literally came from the dump.? I was dropping off the garbage and noticed an old PC lying on the ground.? The power supply and CPU

Perfect time to get that Nickel spray and spray it around the shack so the solar winds don’t fry the front end of our xbitx’s. Joe

I understand that heat's bad.? I'll have to try different tips as I usually use a fine tip.? I usually dial back to about 600 °F when soldering SMD.? I have a couple of recent successes

Hi Allison, In other words we really can't put 10 pounds of balogna in a one pound sack. 73, Bill KU8H -- bark less - wag more