开云体育

Is that the uBitx v5? -- 72 and God bless KD4EPG

I think you meant Hz not KHz. That's easy to check. Put the radio into transmit but do not feed it any audio at all. Do you still see the signal? If so that's the carrier. If it only appears with a

Sorry, I should have also included the place where the receive path is tapped on the BITX40. It is on a separate page here ( http://www.nd6t.com/bitx/Another%20RF gain control ).

Yes, it works just as well on the BITX40. Instructions can be found on ND6T.com here ( http://www.nd6t.com/uBITX/AGCkit ).

Paranormal signal is about eyeballing 1400khz (I think??) below. Receiving websdr is miles away.? If I reduce drive the ghost appears proportionally reduced. ? ?I was told by a club member that my

This sounds more like opposite side band is not being suppressed properly, but hard to tell without more information. If it's a filter problem the signal will be inverted.

On 80M the relays make a big difference to spurs. The ghost will be around -35db at the worst.. not stronger than that. Reduce the drive and see what happens. Raj

I was having few NLT25T-R68J-PF made by TDK, as I bought from comkey.com , a Bangaluru based seller of India. as Per spec they are 5% tol. and shielded. wrote:

You are right Jerry! I goofed on this 330uH !

Gene, Change the relays for sure. 3 axicom will do for KT1,2,3 With relay change the spurs decrease with lower 3rd 5th harmonics. You can change L5/7... they are same as original values or close to.

Hello!? I installed a sound card, checked drive levels, and monitored my psk31 via a online sdr that could hear me. I was thrilled to see my signal...I was getting out!? I was also sending a mirror

I am thinking of putting a dummy load on the unused portion of the heat sink. Mount a switch to select antenna or dummy load. -- Mike AI4NS

My recent ubitx arrived with lsb bfo way off. Possibly these boards are okay, don't rule out something simple. Do note eith no agc, when signals are weak one must crank up the audio gain. Curt

Ok got it.

This was done some years back by a Japanese ham on an amp using RD16HH mosfets.** . I have limited documentation on this matter.? His modication was to put? approx 8T ECW (you choose dia )? on a

Dear friends, Can I use two IRF in parallel in UBITX to increase output power? So total 4 IRF in the final? 73ees John T.P., VU2JON TTRRA 80, 6th lane, TT Road, Kuriachira PO Thrissur 680 006 Kerala

Gene, Here's a post from the old thread on the spur fix: ? ??/g/BITX20/message/60678 The entire thread is worth browsng. Raj found that replacing the toroids at L5 and L7 with 1210

If anyone has an ND6T AGC kit they would like to sell, please contact me. Darryl K0GV

HI Raj, Thanks for the info, I have the relays on order. Should I also change L5/7 at the same time? (Exactly what is the L5/7 Change?, Is it a value change or just convert to SMT?) Gene N2IJF

Okay on SSB without talking that was .80a I forgot to mention that my measurements was taking while pressing the CW key. Joe