开云体育

Kees mine show as shipped but so far haven't received anything yet.? That's why I was wondering how long the shipment takes. Doug referred to Informed Delivery bit that show only a package coming

Ashhar, ? ?I mentioned to Sunil about doing that for his nice cases. ie send me a bunch and save a bunch on postage and I could mail them from here cheaper. Once the one I ordered comes I can

Just curious if many people are using the KD8CEC V1.07 or V1.08 firmware with S-meter support on the Raduino? Using the simple bar graph shown on their various displays and a diode/capacitor for

Allison What is your opinion of using varactors ?in the crystal filter circuit to make it variable. -- Allen ?Merrell

Ray Thanks, I have been checking around on the optical and find that the 4.7k pullup is what others are using with the Arduino as well as an interrupt routine. I see where I also need to make some pin

Hi Kees Have you receive my Paypal paiement now ? 73 QRO Gilles de F1BFU 2018-06-08 18:21 GMT+02:00 Kees T <windy10605@...>:

ok guys got an update on what i was trying to do. when adjusting the bfo in setup the frequency would change but not the shift on the if. but after pushing ppt button it would correct itself back to

that sounds idea a good idea Allen, may do that later.

I used one of the Chinese 400 ppr optical units in a 40/20/30 receiver I completed last month. I ended up skipping 12 pulses before taking action. This is roughly 32 ppr and performance is the same as

The Nano clone that comes mounted to the stock Raduino board that comes with the uBitx and Bitx40 from hfsignals has a CH340 chip. All the $3 Nano clones that folks buy to replace a fried Nano have

I update the list every 1-2 days. You can check the status of kits being ordered and shipped at the link below. Sometimes i make several trips to the Post Office if I happen to be going that way. 73

I'll keep my summary very short: do all the mods you like but make a high pass filter to cut the frequencies below 28mhz. Adding a tuner will also help. That's all folks.

This may be dumb but could you use varactor ?diodes in the filter circuit and vary the voltage to them to change the capacity in the circuit to vary the band width. The Electraft K1 uses this type of

As a complete re-design of the RF low level chain I was thinking of trying BiDiAmps based on MMIC (BGA2851 seems a a good candidate as its price is low) and use BFU550AR for Q90 and 2N2222A for

How do you like the giant fan?? If I turn it on I half expect the radio to go sliding across my desk.? It's gotta go. Lol.

It would be nice would be to have a level 3-5 watts across all bands, 80-10. I was thinking of building an amplifier based on the old Motorola EB-63 application note. The amp would use real RF

Looks nice.? Great idea of re-purposing an old lamp. -- Lee - N9LO?"I Void Warranties"

I've been following the discussion on spurs, but not sure exactly what it all means in practical terms.? I'm still a tech so 10 meters is of some importance to me.? So far, it's my understanding

Thanks Vince for clarification on local shipping charges. Regards MVS Sarma

Here's that pic I promised.? Made from an old desk lamp from a resell it shop.? Not much to look at,...but it serves my purpose.? Used some vacuum tubing to attach the mic element and hot glued a