开云体育

I finally got around to designing and printing ?BITX panels for the EF01 enclosure.? I switched out the LCD for a white on black one.? I ended up recessing it in the panel to avoid the need for a

Basic CW capability using the PTT switch on the mike is very lightweight and?I'd tend to include it on any uBitx build. ? ??/g/BITX20/message/44349 What firmware gets shipped by

I get 3.0 mV to the connector with good continuity to the microphone.

if it was carefully and intentionally engineered with design documentation that will open the door for experimentation then I am all for it..if it was hacked on the fly with no or poor documentation

Well, Ash. It seems to me that there are too many opinions to change things very much. It is probably best to leave things pretty much as is, and let each user determine what's the next best thing to

Think of it this way. I want to add a Tune item to the menu. The item will send a CW signal and monitor an i2c peripheral for reverse power indication while the CW key is held down. Do I duplicate the

Have you measured the voltage at the electret element itself? tim ab0wr t.h.mills@... wrote:

I disagree that the original software is a good starting point for building on as its tuning and keying section need work. I think the uBitx should be shipped with a software that best promotes it's

Tom, measure the voltage on the slider of the tuning pot with a DVM. It should range from zero to +5V depending on the pot position. Also make sure that the tuning pot is wired correctly. The purple

Lead length at this frequency is mostly irrelevant. Stray Capacitance could be an issue in side circuit coupling or if the circuit is oddly designed at an extremely low capacitance level. Stray RF and

Charlie McEwen and I got our licenses about the same time. When we started playing HS football together, I was an offensive end and he played offensive tackle right next to me. We called cross-blocks

Lee said: "I once heard of a ham that could not speak because of surgery and he tapped morse code on his wife's hand "pain very bad" so she cold tell the doctors." My brother and I used Morse once

I've had several people ask me about this since I mentioned it several days ago. To find your compiled hex file: 1. Go to your Preferences settings (File --> Preferences) and check "Set verbose output

https://www.amazon.com/Beginning-Arduino-Second-Learn-Programming/dp/1484209419

I am not yet using KD8CEC's firmware on my uBitx. Does this firmware support the "factory-sent" feature of increasing the tuning step as the tuning knob is turned faster? If not, I won't be upgrading,

I would like 2 of each kit.D Nelson kc2ipx

I would also be interested in 2 of each kit.? Agc and click kit? Jay Davis N3QPW

The lead lengths on my components are not any longer than SMD components. I'm using 1/8W resistors, miniature caps, all mounted horizontally, flush against board.?The 2N3904's are all mounted?flush

So, I just got my uBitx and have it all wired up.? It receives fine.? But, there is no transmit audio.? Here's some interesting information.? I live about 1 Km from an AM radio station putting out

Please add 1 of each board.? Thx Gary K3OS