开云体育

Here is my mic housing, I printed it up to work with the supplied parts.? The element drops in to the hole, the button snaps into the side, the three posts have holes in them to wrap the wires for

Hello I am planning to buy/build a uBitX for dxped use. But not sure about CAT control and VFO split ??! Best Regards, Stein-Roar Brobakken post@... LB3RE K3RAG Skype: lb3re.rag

Thanks Ashhar, Paul

That is to be determined based on the performance I get. Right now, I will adjust VR1 to get 5 watts on 40 meters and go from there. Howard

Sorry, I meant to show a picture of the front of the completed mic also... -- I always thought the Universe was a wonderfully strange place until I studied Particle Physics - I now know the Univ

I used an old Regency CB mic case, removed the old mic element, cut down a small plastic funnel to fit where the original mic element went and cut the other end of the funnel at appoint where a Radio

Accidentally included the same picture twice - here's the one I intended to post showing the real time clock & voltage monitor on the screen -- that V308b is a beta version of software and even though

Norm. Vk5gi Probably no mike gain control because the audio input is designed for approximately 45 millivolts level and the included electret microphone puts out approximately 45

There is am article in the swedish magazine, the QTC about using the rtl-sdr with ubitx. - f [email protected]> wrote:

?????

My mic has its own processor

Finally have this one where it will get it's top cover put on and the radio goes into the "go box".? With the addition of one of our RadI2Cino cards, an I2C 4 line by 20 character display, a Teensy

Max, Here are the direct links to the images showing TX/RX LED wire-up for Sunil's (VU3SUA)?enclosure. 3 wires soldered to

So you're the guy who read that QRP Quarterly article! Jack, W8TEE

You were getting 25 watts Peak-to-Peak? Or you were getting 25 volts peak-to-peak? tim ab0wr davesters@... wrote:

Gee.... I wonder who gave me the idea for my mic?? :)? Thanks, Jack! Tom AB7WT

Unless the display is changed by one of the other tasks there is no reason to update the display. It's not like you are preventing the other tasks from running while you automatically update the

Mine with a stock electret: Made from some plumbing parts, phone extension wire, some too-big-for-anything-useful shrink tubing, and hot glue. Total cost: $0.87. Guess who has the greater building

Unless the antenna is picking up a static charge and the antenna tuner is acting like an impedance to ground draining that charge off. Don't laugh, it happens. Dr. William J. Schmidt - K9HZ J68HZ

Here is one of mine made in a aluminum pen tube with PTT inside. Joel N6ALT