开云体育

I'e used several obtained from the local Craft stores.? They are cheap and I can get them large enough to not only contain the transceiver but also a reasonable sized battery, key, Mic, and manual

Nick: What is the cost of this board.? I have a Micro BitX encased in a Carl Beck composite case (which I will add shielding to while I redo it.? Will this board add new features?? I would like a

I just ordered a red case they are taking orders again chris G0WFH wrote:

1970 SSB Handbook Regards Lawrence

William's wizardly wood workmanship warrants warm well-wishing.

Bob, Thank you for the feedback. I am starting to write a Memory Manager guide, and this is valuable feedback for that process. Currently I do not have the answers. I will collaborate with Ian, and

The fix for the missing sidetone turned out to be very simple - a .1 (104) cap in series with R253 to block DC. Howard

Boxing up my uBITX -- Question for the Group | | | | | | | | | | | Boxing up my uBITX -- Question for the Group Radio electronics blog. Homebrew ham radio. SolderSmoke podcast. QRP |

Rod, et al., ???? I am running the CEC FW v 1.061 and using Memory Manager v1.01 and I have several questions. Features that seem to work well include: a.? VFO A and B and their modes being set

Thanks Lawrence for the memories, Your scan rung a long dormant bell (nostalgia face here). Do they come from the ARRL SSB handbook, where you scanned it from, or an original QST article sometime

Hi my ubitx was posted via India mail on the 12th April and received today on the 14th just 2 working days and no customs charges brilliant now the fun begins.

Mine has FCI and Pl1 then TDA2822M on it, have had it on RX for quite some time. Phil - G7BZD wrote:

WX is the marking. Ideally cut the 12V track and feed 9V from a regulator. I use a 78L09 soldered on to the board as a hear sink. You can use a 7809 or 7808 on the chassis and run a wire. Raj

Do we know what the markings are on the faulty IC's Phil - G7BZD

Nice PAUL, Don't just increase volume much and don't immediately use ear / headphones. *Many buyers, are perhaps not using the experiences of others.* The do irrelevenat and then only relaise after

On Mon, Mar 5, 2018 at 07:46 pm, Jerry Gaffke wrote: > > Set bias for 100ma of drain current on each IRF510 using RV2 and RV3 and > then leave it be. > That 100ma shouldn't change much even if you

I can agree. The vast amount of help received Seems to have got me sorted with rf at the dummy load. Just now to get it on air for a signal report. -- MM ? WXT GQRP - # 15057

Thanks Nick. MUCH easier on the eyes… Dr. William J. Schmidt - K9HZ J68HZ 8P6HK ZF2HZ PJ4/K9HZ VP5/K9HZ PJ2/K9HZ Owner - Operator Big Signal Ranch – K9ZC Staunton, Illinois Owner

PDF Version

Here we go folks: 73