开云体育

Thanks Richie...that was probably you I heard earlier right in my noise floor. Looking forward to radio contact. Too many chores today to spend a lot of time on radio - i know - poor planning on my

Well, i have dont my mods and powered up. Results are mixed: Here are the mods. RD16 replace IRF510. New output transformer 1:4 BN43-3321 with a 330pf cap on input. feed back resistors. from 22ohm to

Was able to speak briefly with NX2U and then the band dropped out. Made first contact with my ICOM-7300 and then set up the uBITX.? Had a few words with him and then nothing.? Using an LDG QRP

Thanks for your information! 73 de BV5DD 2018-03-12 6:15 GMT+08:00 Glenn <glennp@...>:

7:45 local time in EST - where is everybody hanging out? Not hearing anything except my neighbours washing machine and I don't speak "machine language" .

Hearing NX2U off an on. Called, but no answer! -- John - WA2FZW

On my latest BITX40 I snuggled the display up next to the edge of the case close enough to enable easy access through the side of the cabinet with just a minuscule aperture. Hardly visible. On the

Was able to work Nx2U and one other operator. Hearing carrier from 7.25mhz.? 7.29mhz is better

Jerry, Diddling with the BFO to make it a clarifier is not good. I agree it is a bad idea today. It worked back in the 50's and 60's because there wasn't much of any other choice and the filters

I think we finally have everything defined correctly. You and I agree. The design of this radio is impressive. I've had several home built receivers where switching between usb and lsb involved

I'm looking for ideas on what others are doing regarding mounting a micro USB connector to the ubitx case.? I'm finishing the case customization and would like to be able to connect the raduino USB

Marco I bought the MPSH10's about 5-6years ago. Perhaps less of an issue with fakes then. glenn

Hi John Totally out of the box uBITX, (ie no mods)? I checked power out in CW mode 120118 Checked using CW key at 12.5v dc in. VR1 at ~60% anti-clockwise. (factory setting) ·?????

Also,? there is a site and you may have seen it because the owner of the site, Don, ND6T is active here. What he does is put a little code in the Raduino and tell it to go directly to 25 mhz. He had

Thanks to all for the great input!? Now, I've got some good direction on what to do next.? Very helpful! Bert, I got the tuning knob idea from a vintage Swan 270B I have torn apart for repair.? I

Here here & Amen ?, I have always advertised ham radio as a "gentleman's hobby" (ladies too of course ?) let's not get caught out and bring this thing we share & enjoy into disrepute! Bill

Hi Marty: If available I will take it. Paypal to ???? Tim WB7UVH Links: ------ [1] /g/BITX20/message/44251 [2] /mt/14478139/535143 [3] /g/BITX20/post

Hello Glen, Very interesting. Do you have measurements of you final's power across the bands by any chance? All the best, 73, John? (vk2eta)

Well, that was another thing that got pruned out the original document before posting as 44182. All that 44182 has to say is: ??When adjusting the BFO, we should move the VFO to get us back to the

I copied N5KYD @ 20:10 and W0OIC @ 20:41. I am in Western Kentucky. Using my bits40 for receive, can not transmit at this time. Denis, WB8SKP