开云体育

For uBitx and Bitx40 connectors, google for "KF2510" Originally by Molex, I believe. You will likely be adding the wires, I haven't seen complete harnesses, but then I haven't looked very hard. Here's

Hi Walter, Michael Hagen gave you an answer but you asked for a schematic so here is a quick, down & dirty representation of what N5IB was talking about - it shouldn't be too difficult to add to any

Ok Thanks? That clears that up -- 73, W9KJO Walter

Well, the Encoder is usually handled differently on UBit vs BitX. When changing from a pot to an Encoder on BitX,? I went for the interrupt routine method. I added 10K pullups and 0.01uF debounce

anyone know where to get replacement harnesses for the bitx40 ... ?

Hi Mike (VA3MW) Times definitely have changed, and yes, today anyone in Canada can buy, import, sell, own,? -a radio transmitter without any restrictions (using it without an applicable licence is

Is this for the MBITX? Could someone draw this up?? I'm not sure I understand what is being described.? A little schematic would clear it right up. -- 73, W9KJO Walter

As N5IB said, the ALPS information is good to know. I've been involved with the "RadI2Cino" pretty much from the beginning and the 10K in series with .01uf to ground (.1 on the ones I've built

ALPS, a maker of rotary encoders, recommends 10K pullup to Vcc, then 10K in series with 0.01 uF to ground. The internal pullup in the ATMega is loosely specified - somewhere in the tens of K, max

Thanks Mike. 73, John

Wonderful work OM Mike. We all appreciate your efforts in real ham spirit. If I find anything interesting I will point it out for you. Thank you for your great work on consolidating knowledge from

Upgrade the software ... there are two variants discussed on this list.? Ian Lee KD8CEC software should fix your problems and requires no hardware mods. If not, this will be because the resistor

It looks as though Comcast has blocked groups.io for its customers.? Hopefully, it will be fixed soon! Ron W7HD

Correct. I noticed that when I was wiring it up, but had forgotten this. Philip, G7JUR

Seeing Mike Woods' update for ubitx.net got me wondering what the usage on bitxmap.com ( http://bitxmap.com ) is looking like. We have 306 operator entered map points and 13,437 total views.? All

Sounds like you need to increase the size of the swap disk. It's working for the moment.? Sent from Yahoo Mail. Get the app

It also shows that the CW key ("Digital Plug" Blue wire) is connected to the "Ring" of the key jack, not to the "Tip" as it really should be. I've tried to call this to Ashhar Farhan's attention since

i was thinking 2nd nano and i2c lcd maybe a 20x4, leaving system rad do its thing unencumbered. dc voltage current, swr, rf power, s meter, real time clock etc on health display. still dreaming but i

The wire up drawing has an error regarding the volume control connections. It shows the orange wire as being Vol_high. And the yellow wire as being Vol_mid, going to the wiper. The orange wire is in

Does anyone have a complete parts list for the ubitx?? I am looking for the values of the audio pot, especially, but also a physical wiring diagram of the connectors. Ron W7HD