开云体育

Thanks for the reply Allard. In non SPLIT ( normal ) mode I am trying to use VFO A on 7.177mhz LSB and VFO B on 6.622mhz USB. If I switch from A to B the display shows 6.622 USB but actually receives

the toroids arrived today for the rest of the backlog. for those who missed the last update, there were no T30-6 toroids left in the world! Diz managed to get a few thousands to complete the backlog.

Just got Paypal notice that ubitx has shipped. I ordered on December 13. Tracking says that with my DHL shipping it will arrive in Michigan on 1/16. KC8IFH

Thanks Herman, that's what I'll do. I will report back when I get it done. Dave

I am so happy to have mine. It is together and apparently working. I had a mistake on the tip/ring connections for my Mic. Fortunately I plugged it into my dummy load. I have not had a QSO yet. It

Ordered mine Dec. 13th and it just shipped an hour ago as of today. -- ---------- N5WLF, Greggory (or my nickname, Ghericoan) General Class, Digital Radio Hobbyist

I ordered mine on Dec 12, paid $109 for it (no extra for shipping) and got it two days ago here in Michigan in a big yellow DHL package!? Karl, KO8S

SolderSmoke Podcast #202 Cover-Rig, SKN, Pete's Vector Boards, uBITX, K1BQT rig, MAIL | | | | | | | | | | | SolderSmoke Podcast #202 Cover-Rig, SKN, Pete's Vector Boards, uBITX, K1... Radio

Ordered Dec 9, confirmed Dec 15 and arrived yesterday by regular post. 73 Ken VA3ABN

Me too. We can but hope :)

i forgot which frequency please? Regards MVS Sarma garello@...> wrote:

I am attempting to build a specan Spectrum analyzer from Ashhar's blog, Does anyone know where I could order matched sets of 4 or 5 xtalls? Andy-KM4TRT

I hope also ordered the same day !!!! f6cht.

Yay.? I ordered mine on the 15th of Dec so it must be pretty close to shipping.....

Hi Dave, That's what I did with my Bitx40 which has the same circuitry. I addition l've put a 10k pot between the MAX9814 board and the C on the Bitx, so I could define the limit. Transmitting is much

You could just remove power from the IRF510. Then it's safe to play with transmit, no dummy load needed. I did that when debugging my transmitter, everything works normally till you get to the IRF510.

Anyone know where (in the US) I can find those connectors (female) and the crimp on pins? I need to make up some of those connectors to wire up test connections to a Raduino so I can test the CW stuff

Regarding putting diodes near the front end of the uBitx, this post is worth reviewing: ? ??/g/BITX20/message/35656 And this thread, which continues the discussion: ?

Yes, thanks Raj. I was confusing the pot numbers...I was adjusting RV1 not RV136. Found the problem to be a dead Q13, which seems to happen a lot! =Vic=

I tried the 90.1 uF cap in series with the AF filter output but it didn't help. My filter is always on, but there is no noise from it when it is bypassed, so I don't think it is generating noise on