开云体育

Steve, if I understand correctly, you have sBitx v3 hardware. I recommend upgrading to 64-bit, the forum discussion for which can be found here: *New sBitx V3 to me (

Got my zbitx updated. Cells charged. FT8 working but no qso as yet. Tring cw mode. Can't make any sense of decodes a stream of T & E which I suppose is to be expected. Tried different wpm to no

The description of point 10 of Digitalis mode on page 21 in zBitx-User-Manual-.pdf is incorrect. It should read as follows: 10. Choose plughw:CARD=Loopback *_1,* DEV=0 as the Output/Playback

Device manufacturers typically install the cheapest available components. If someone is bothered by the quality of the component, they will replace it with the one that suits them best! This is just

The cable provided with the zBitx has a connector on the end which I would describe as a "crab claw" contact to mate with the female connector center pin. In my opinion, I would say the "claws" would

Leo, I can't write any helpful information for your problem because I don't know where and how the sbitx and zbitx programs are separated. What was transferred from sbitx and it's also confusing to

I tried to update my sBitx but got the error message below. ?I checked the sbitx directory and found “oled.c” instead. Please advise how to update my sBitx V3. Thanks, Steve WE5K

After reading the forum, you will find answers to your questions in a lot of information. In the Home column, the last Wiki caption is where helpful information is collected. On the messages page, in

Hello. The update doesn't work, I only get a gray lcd, and nothing on the computer.I got a USB cable with a C type with the station. So I used what I have at home.It asks if there needs to be a

Thanks ! Can't wait to receive my zBitx - then measure up and start designing a rugged case / frame for it. Screen cover / protection, carry handles, strain relief for cables etc.

Here is what else I am seeing (I hope this helps). When I start wsjt-x the zbitx frequency changes to 14.074 which is the default ft8 frequency. I am able to change the zbitx band ONE time with wsjt-x

Yes I am in digi mode. Receive works just fine. The issue is that (a) CAT is not working (b) transmit does not work (c) since cat isn't working (d) can't change band/frequency from wsjt-x. What I

I hope you guys are using digi mode to connect with any other application [email protected]> wrote:

Fldigi hamlib settings don't work either. Leo, AI5II wrote:

My bad, you're right - sorry for confusion. The best advice is to reach out to HF Signals directly at sales@... to get the correct answer Ken, N2VIP

Where did you get that information from?

I went to the buy page and its saying sold out on the sBitx [email protected]> wrote:

The sBitx is apparently offered for purchase right now: https://www.hfsignals.com/index.php/sbitx-v3/ And the zBitx also is apparently still offered for sale right now, but with a 4 week lead

When will the sBitx be back for sale

I should mention I've updated to the latest firmware 1.06/3.051.