开云体育

Excellent! ?Will update both Thingiverse and GitHub. Might be a few days as I don’t have access to my development system. But it is great benefit to others! 73 Mark -- AJ6CU/7 KD8CEC 2.0, Nextion

The uBitx V6, with Nextion display and KD8CEC software, does have a screen saver mode. This is accessed via the Control Menu, LCD button. The LCD Setup screen allows setting display brightness, and

Thank you! Scotty WD4PYT

That could be. How are you powering the Pi? For the final build you should use a buck converter set to about 5.4 volts and power the pi through the GPIO pins.? With that, I had no problem picking off

I've updated the CW macro display in the GUI. While it's not perfect, it's an improvement over having many of the macro buttons missing. Frankly, the default GUI leaves much to be desired and really

I sent you an email Evan, I don't know how to do PM here. -- '72 Aaron K5ATG ( http://k5atg.com )

Hi Mark Files uploaded to Thingverse. https://www.thingiverse.com/thing:6547714 73 Glenn VE9GJ

Hello Aaron, The Nextion display has a built-in backlight adjustment via an app that can be included with the screen TFT file.? The one issue is the noise generated by the PWM used to reduce the

Hello fans of BITX. I have a uBITX V6 that I upgraded to a Nextion display. I'm selling it to my close friend and he is wanting me to do stuff to it that I never did because I personally did not

No problem Lars and great job with the mods. I am running your codebase now and I appreciate the enhancements. Does the world map work yet or is that still under development? I don't see any pins on

Hi all, Sorry for the build error. I have fixed it. Furthermore i have discovered and fixed a grave error that caused "decoration markup" on the the F8 response sendt when clicking on a CQ message in

thank you Paul. I'll try and report later. 73, Yvon AE7YD

sBitx V2 for sale. Includes the original box, documentation and spare set of finals as delivered. SDCard has been upgraded to V3. This is the full kit with Pi and display. $350 shipped in

Great, I will do that. I had to increase the horizontal dimension by about 1mm for the display "pocket" and ended up doing a slight shaving with a knife of the the pi ethernet and BNC hole. 73 Glenn

Hi! Not at all, I am fine with it being a few watts off and this was my suspicion already. Good to have that clarified. Just made my first QSOs with the sBitx and got only good reports regarding the

Mark, thanks for the response. I put the main PCB in the box and it is a tight fit. So much so, that the PCB does not need screws or the nuts for the BNC or the three 1/8 inch jacks to secure the

I mean, maybe using an external PSU was the solution

Ashhar asked to see their hw_settings file and that will be key, also, in addition to the ideas presented already. Remember that at least in MY units, the upper side band is at a disadvantage due to

Thank you Dean and Evan, The codec is working. The GUI starts. The Si5351 is also working (confirmed on spectrum analyzer) I guess I should start working on the hardware part :) before worrying about

Hi Andi, There is no calibration for the SWR/PWR meter per band.? If you were to calibrate for 10 meters, then 80 meters would most likely be off.? I believe that most sbitx power measurements are