开云体育

It is written in simple C. The web UI is javascript.

What programing language is being used for the development of the sBitx v1 and v2?

Hi, which is the correct files for ubitx V6? Thanks. Andrea Inviata dal mio Xiaomi Mi 11 Lite NC. Il lun 12 giu 2023, 03:59 secondchancesailor <jagillaspie@...> ha scritto:

If you remember, I had reported self oscillations in the PA for a few microseconds at TX to RX and RX to TX transitions the PA as well as T/R switch are both switch on, creating a feedback loop. This

Hi Ashhar, That worked. ?The radio changes between transmit and receive properly. ?Thank you. Where was the problem? ?Something controlled by CAT? ?Just curious. Thanks again, Scott

Scott and others, I have fixed this issue in the latest update. Can you try it and let me know? - f [email protected]> wrote:

On the left, where the inscription hw_settings.ini -- Gyula HA3HZ

Gyula, In the screen capture, can you tell us which file is yours? - f

Thank you very much for answering my request. For me, the comparison of the two ini files looks like this after I performed the May 4 update, then the SWR/Power meter calibration and finally performed

Hi Ashhar, Just add hw_settings.ini on a line by itself in the .gitignore file. Best regards, Vasu

Hello Gyula, My sBitx v2 broke the final and I ended up having a new board sent to me. It just arrived yesterday, so it has probably been adjusted. The settings are as follows. Ichiro JE1JGC [image:

I'll help you: the files are in the */home/pi/sbitx/data/* folder and you can copy them to a usb stick with the file manager. Or you can click on the file to view its contents and take a picture of it

Ashhar, I have the same problem with the new software when running ft8. -- Bob AA4FJ

I have added the .gitignore to the repo. can someone run ./update and see if it works on your end? wrote:

This is a brand new SBITX transceiver made in India by Farhan. This transceiver runs 20 to 40 W output, depending on the band covers, all modes including digital modes and includes a built-in

Hi Ashhar, That sounds like what'is happening.? When I change the frequency, I definately hear a relay change of state. Also, before the recent software upgrade, when I powered down the sBitx, I

Hi Gyula, Thank you for reply, But I'm not sure that it will help, as today I investigate the routine of the Sbitx . As I'm not so familiar with the Raspberry pi "batch file", I just explain what I

https://www.atlassian.com/git/tutorials/saving-changes/gitignore Hope this helps Regards Daniel [email protected]> wrote:

Hi Nir, You can find the information you are looking for on www.cqsstv.com ( https://www.cqsstv.com/ ). There is a problem, because if you haven't downloaded the qsstv_9.5.3.tar.gz (

Git ignore https://www.deployhq.com/git/ignoring-files#:~:text=Creating%20an%20ignore%20file,a%20file%20should%20be%20ignored .