开云体育

Raj: Thanks so much for the reply. The mic polarity is correct and the Mike functions well when tested on other equipment.

is it not time to split this group into? v1to 4 , v5? and version 6?? i have no interest yet i v6 but wading through v 6 infois a waste of time

I used shielded cable to and from the filter, board situated on left hand side of main board between the main board and the case side. I also used the soyabeans lm386 amp circuit with balanced inputs

Andy -- my uBITX did for me exactly what you want the uBITX to do for your class. So push on. This groups.io is a unbelievable resource. There are more kind folks here with more smarts and experience

Did you use shielded cable to and from the filter?? How close is the filter board to the uBITX board?

So if they were rushed Thats why theres so much damage and missing parts to my v6, theres a 7 mm scratch in middle of the tft screen thers a badly bent on/off volume control..missing screws which hold

I have not used external computer digital modes on mine, except to test rig controls. However, I use a Signalink on my big rigs and it should be no issue on any rig that has a mic and ptt input as it

Cool ;-) -- PE3ES - F4VTQ - Erwin 73

@Jim Sheldon, in this case it would be advisable to read and note the original calibration settings before doing the actual install of a new firmware. Also as far as I understood the findings of

Failure of the device can be a concern, however in the Raduino the thermal shutdown should kick in before damage to the regulator.? This will cause erratic operation of the Raduino, rather than

Here's a better resoution picture of the radio box.

That's what the DVI cable is for. It seems most often used as a computer monitor cable out in the world and not hard to come by on the surplus market.? The first prototype for this was built with the

Martin, The version 6 is current and for sale through the HF Signals site. Farhan has advised delays may occur in dispatch of current orders as the workers were working a full speed in order to fulfil

Cheap replacement unless it’s failure mode is to send Vin to Vout, then… ouch. Clark Martin KK6ISP

Hello to All, I'm rather confused. Just bought the V5 version, got it up and running, including the software-change. Then the V6 started to be offered. And suddenly the V6, which is far more expensive

Ashhar, Did you want me to make these changes, or do you plan to merge the PR as-is? Reed

Hey Ted, lots of good stuff there!? Let me throw back a few questions: - What's the communication between the uBITX and the remote control head?? What's the distance of that cable? - Did you have to

Your problem seems to the mic connection. Check the wiring polarity if you are using the supplied condenser mic element. One of the two solder points on the ,ic is visibly connected to the mic

Hi, and welcome to the group.? Does your SWR meter show any forward power?? Do the heat sinks get the slightest bit warm after 10 seconds of CW or hard audio into the mike?? The uBitx LCD will not

I am a newbie, with my first build. Completed as documented. Rx works well. Even with minimal indoor antenna, I received station from 500 miles away. However when I attempted Tx on 50 ohm dummy or