开云体育

There are a lot of videos related to the uBitX on YouTube that can add details that are missing in the ARRL video. Matthew N8OHU -- Sent from my Android device with K-9 Mail. Please excuse my brevity.

ARRL isn't a marketing firm, and I believe the video is kept behind a paywall for subscribers only. Again, you can't buy the uBitx without going to HF Signals, who makes it very clear what is included

Dean, I assume that you were whistling or saying "Helloooooo" into the mic when measuring.? My v4 and v5 uBitx both do not register power out until audio is applied. If you were able to calibrate

After a short discussion on EMRFD regarding the "minimalist DC receiver" (which uses the same gain stage design) resulting in a detailed explanation from W7ZOI (see there if interested), and

Ken Hansen, yes, agreed,? the QST article does make these points. The video will be seen by many who do not have access to QST and who are not familiar with the uBitx and they will get??information

Thanks Dan - I will give CW try. I have a watt meter on the antenna output so that is how I know there is no RF out. The mic is a cobra/uniden electret CB mic.? I believe the element is essentially

Dean If you haven’t tried it you might go into cw mode and see if you get RF power out in that mode. You can just use a piece of wire for the key if needed. If you get CW power and the mike ppt

They make it clear in the print article that the case was optional, citing the source, cost, and shipping, as well as including a stand-alone photo of everything that comes with third-party case they

I was licensed in 1972, and rock bound. I built my transmitter from plans in QST and used it for my first QSO. my dad and I were both licensed at the same time. WN7UHW &WN7UNW.

Hi all - Thank you for all the suggestions and advice. Here is my uBITX 5 post calibration video ( https://photos.app.goo.gl/zTFArxhCUFT7fD3X8 ) The solution to my garbled audio turned out to be

Hi Vaughn try https://github.com/amunters/bitx40 and set the required tuning range in the SETTINGS menu 73 Allard PE1NWL

Glad to see more coverage for the ?BITX but the video showing an aftermarket enclosure as if it is standard is only going to create confusion. -- www.bitxmap.com ( http://www.bitxmap.com )

Definitely by the time I got my novice (late 70s) VFOs were allowed; I quickly came to appreciate the value of that VFO.

MVS Sarma Definitely the LM317 is more power hungry. Have a good sized heat sink on it. It has to adsorb 5 volts at maybe 150-200 milliV But a linear is quiet and I thought that the having the receive

Actually, the value of the pot is not that important and a 10K will work as well as a 100K. The pot is between 5v and ground and you are just adjusting the voltage when "tuning" and that doesn't

Review video not up to usual ARRL standards - could have done better.

A couple weeks ago I released a fan shroud for the "tall" Sunil case. See https://www.thingiverse.com/thing:3790450 Since then, I was curious on its effectiveness vs just heat sinks or heat sinks and

Gordon covered the Q70 biasing arrangement very well, too. Tom, wb6b

So there is a early draft users guide in the folders section with the following calibration steps. There may be better instructions in some other guide.? I am way too lazy to do a complete search.

The fact that you have to turn into a higher frequency indicates the internals of the microbitX may be at too lower frequency but you will figure it out. Try anything, it will either get better or