开云体育

Sunil is not sending goods with a value less than $25 at the moment. Something to do with DHL and no India post. He will cancel the order if it's less. It has just happened to me. 73s Ken

Hi Dave, Did I miss something? Deviation is an FM measurement unit. I didn't notice that you are using your uBitx for FM. Are you doing that with SDR software? 73, Bill KU8H -- bark less - wag more

Format: No Signal,(comma) Signal peak to peak volts (i.e. 1 mv (no signal) , 2mv signal generator on) Input 7.150MHZ signal 1khz deviation 30 mv at antenna direct connection Q10?? b 70mv, 70 mv c

John, Sunil sells his front board / wiring kit a la cart for $15 + shipping. https://amateurradiokits.in/product/wire-kit-and-board-for-front-panel-ubitx-case/ No difference in v3/v4 board wire-up.

I have a working S-meter under VK2ETA version of KD8CEC firmware. I am using a 1602x2P display. However, when I implement KD8CEC's v 1.071 I cannot figure out how to enable S-meter in the display. YES

That should be 'good enough'. You might have to pay a little more attention if you want to use the rig in a frequency measuring contest. That isn't necessary for just everyday operating. 73, Bill KU8H

Pretty much according to the instructions...? Set the CAL to zero beat against my 20 MHz reference standard.? Then adjusted the BFO until got a good RX signal.? First used a signal from another

I bet that Wiki is cool but it sure is nice to get the info LOL

Does any one have their oscilloscope peak to peak volts measurements for the receive transistors (with a specific signal generator volts/ of of course)??? Q10,11,12 base and collector and Q30,31,32?

The latest version is v1.28.1, but v1.27.7 should also work OK. It should work even without any of the modifications as described in the instructions. However, I would recommend to at least install

Evan, it is simple. I uploaded a file refresh_eeprom.ino ( i GOT IT FROM MY CLOSE FRIEND OM MAHESH VU2IIA AND WORKED FINE FOR ME) 1. place the usb card and connect it to your laptop. Of course I use

This is a great idea/process when used with the CEC sw and memory manager.? One thing I did do was find an offline program: http://www.techmind.org/audio/specanaly.html Was real easy to use a usb mic

I used a 'random noise source' and Spectrogram? (maybe still? available on ELECRAFT K2 website) easy/peasy Jim

sold

sold

Hello - I tried searching the messages here and can't find any info on this: I am finally was able to start on putting my? early ver 3 ubitx boards into one of Sunil's great looking cases. The case

Thanks, interesting.? May have to think about something like that since it just doesn't want to hear much at the moment.

Thanks didn't know that but retried. Still signals seem very faint/garbled.? Even tuning around things don't get better.? Seems like it just can't pull the signals out of the noise. I can tune

I would take the setup

Just checking something, Woody and Dave, when you do your BFO adjustment, you know you to adjust both the BFO and the tuning of the receiver?? You can't just stay on one exact frequency as you adjust